Hello Guys,
After last summer I decided I need AC in my 260 Sundancer. I got a great deal from Mermaid Mfg...I plan on getting started this weekend as I plan on it taking 2 weekends to complete. Just wondering if anyone has any pointers or suggestions before I start. I have already removed...
Just wondering what you guys think about painting the trim tabs or not...They are stainless steel...The previous owner had painted them but i am wondering if i should just take them down to the bear metal and wax them or clear coat them.
On another note should i clear coat my props or just wax...
Hey guys,
So I am seriously thinking about installing a AC unit in my 03 260 Sundancer. The boat never had AC from the factory. I was wondering if anyone here ever installed one of scratch and would like to share their experience with helpful suggestions. Some of you have had great...
So does anyone have any recommendations on how to install a fresh water flush onto a 5.0 mpi salt water cooled engine. I think it will be a real pain in the arse to put muffs onto my drive while at the dock to flush after a day out.
When i have to switch from reverse to forward the shifter hangs up a little bit and have to give it a good nudge to get her into forward or return back to neutral then try going forward again and she stills ok. Any recommendations? I tried greasing her.
Ok guys so I want to install a fresh water flush kit onto my engine to be able to flush out the salt water when i get back to the dock. Any suggestions on how I can accomplish this without buying a $250 kit? I would assume I can tee off the sea water pump or somewhere by the thermostat?
Ok guys. So I ordered my parts today...The manifolds look good inside so I am not replacing them...However they do have a small amount of rust on a few places...I have this Rust no more acid which you can apply to metal...They say let it sit for 24 hours and then rinse it off...
So I was checking out my engine last night and saw rust on the outside of the riser. I assume I should pull it apart and inspect and change the gaskets at least correct? It appears the riser is held in place with studs as opposed to bolts. There is not much clearance above the riser. If I...
I have to replace the water heater in my 03 260 sundancer and was thinking of lift the base of the heater 1" off the floor in the engine compartment with 1" square stainless tube. Anyone think this could be a problem? Also the heat exchanger portion of the heater is filled with rust. What...
Should i paint this area (under where the 1st prop) is on a Bravo 3? Doesn't look like it was ever painted. I know not to use paint with copper or tin.
So I took the plunge and purchased a 2003 260 sundancer in perfect condition. However I do not like the name of the boat and was thinking of changing it but I hear it's bad luck. Wondering if other people have changed the names on their vessels and if in fact they had bad luck. :)
I am in the process of purchasing a 2003 260 Sundancer. It is currently shrink wrapped so I cant get into the engine compartment. I was wondering how the engine cooling works on this motor. It has a bravo 3 drive. I used to have an alpha drive on my old boat and had to replace the water pump...