Search results

Great. Thanks for info and suggestion.

I am looking for the secret (sequence) to adjusting my cabin door. Sometimes I can barely get it to move and when it does slide it does not slide smoothly. It will intermittently grab onto the track preventing it from opening easily. I know there are 4 screws on top of the door---just not sure...

Thanks, Dave. Happy to report I achieved success. I thought it was like the strainer on my generator which unscrewes from the bottom.

ahhhh nice tip!

Thanks, Dave

Can anyone tell me how to remove the A/C water strainer. I have looked and looked at mine. Seems the only possible way is to remove the 4 screws "underneath"; 2 of which are pressed up against the gas tank. There must be ab easier way.

A/C fresh water strainer It is not immediately apparent to me how one removes the strainer from the housing. The only thing I can see are 4 bolts that screw in from the bottom up. Anyone know how to get the strainer separated?

I had a Windlass installed on my 2007 260 this summer. Cost was less than $1,000, I continue to be able to store bumpers for the bow in the anchor locker and remain thoroughly satisfies with my decision and the Windlass itself.

The main cabin floor and carpet was soaked. Discovered a good 3 inches of water in the "well" where the shower sump, A/C condensation, etc is located along with an "emergency pump" and an attached float switch. Given the accumulated water I had to figure the emergency pump was not working...

Can't recall off the top of my head--will check next time I am at the boat

thanks, I think I'll practice on spare ropes first

Thanks. Now to find someone who knows how to do this!

I just had a Lewmar Windlass installed. I'm getting mixed feedback on how the anchor rope should be prepared to attach to the chain. One camp says use a rope with a braided loop. Other camp says to use a thimble and a wire rope clip. Is either correct? Are both correct?

thanks I appreciate it

My 2007 did not have a seaL. I installed several layers of adhesive backed weather stripping and it sealed up nicely

No longer getting a depth reading or accurate Sea Water temp from the Mercury Smart craft. Looking at the Sea Ray parts list for 2007 Dancer, it shows that the through hull transducer provides both depth and water temp. It is listed as an Accessory, Mercury Smart Craft. Sea Ray does not...

Having trouble finding a replacement bulp for swivel light in cabin. Calls for HALOGEN 12V 10W BI-PRONG, can only find bi-pin. Any suggestions for where I can purchase?

Thanks, Dave. That is most logical explanation I have heard and I appreciate the link. Matt

Have tried unsuccessfully to replace the rocker switch that controls the main cabin light fixture (halogen bulb) with 2 different dimmer switches. Can this light be controlled by a dimmer and if so how? Light works off battery, generator and shore power.

I have not but will do. Thanks, Dave Matt