Fresh water pump repair.
I went ahead and bought the entire bottom end of the pump vs just replacing the inside diaphragms. If you buy the parts separately it's more $$$ than buying the entire bottom end assembled with a new pressure switch and all so it was a no brainer.
So off with the old and on with the new. Instead of using crimp connecters I soldered with heat shrink to make up the connections. It just looks better. I'll use crimp connectors tomorrow when wiring the pump back into place because I'll probably be in my head during the reinstallation.
I had to disassemble the old pressure switch to remove the 2 red wires to reuse to wire up the new one. Even with the slight design change from old to new it was straight forward.
Following your thread with interest. These are the kind of details that will benefit any model. One thing to note, however. Its generally not recommended to use solder connections on a boat. Solder connections are brittle and generally don't hold up well to the vibrations.