I have a Mercruiser 350 MPI on a 2007 260DA. Was coming into port last weekend and stalled as I entered no wake zone. Made it back to slip and thought nothing of it. This weekend she won’t start unless I give some gas in neutral and the she stalls again. Thinking it was IAC. Asked marina...
My depth finder stopped working this season. I had the boat pulled for another reason and looked on the bottom of hull. Took a picture but can’t figure out if clouding on the hull would prohibit transducer from working. Any ideas or experiences I can tap into?
My depth finder stopped working this season. I had the boat pulled for another reason and looked on the bottom of hull. Took a picture but can’t figure out if this would prohibit transducer from working. Any ideas?
I have a 250 DA and depth gauge stopped working. The boat was pulled for another issue, so took a picture of the transducer in the hull. The question is will transducer still work with the “muck” on the outside of transducer as shown in pic. Or is it time for new transducer?
thanks!!
My boat was recently commissioned (mid-May) and was supposed to have been painted with new zincs. The boat had to be taken out of the water last weekend due to a leaking hot water heater that filled the bilge because the bilge pump was not working and the engine hatch was not working.
While...
Had the marina mechanic take a look - they pulled the boat out. Turns out the engine hatch problem was due to a magnetic switch that keeps the hatch from opening if the stern door is closed. Funny thing is the boat was just commissioned, so this should not have been a problem. The factory...
Three problems: 1. My engine hatch is not working 2. my bilge pump is not working; 3. leak from engine coolant hose. Boat SOL.
Opened access hatch to pull pin, only to find it is not a pin but a nut and bolt. Cannot unscrew nut and bolt with one hand due to only being able to fit one hand in...
I have my suspisions about mechanics motives. I leave the drive in the down position in the slip, dry stack in winter and boat is in water from May - October. The boat is 5 years old, so based on feedback, this seems to be about the lifespan of bellows, correct?