Hi Tom, Thanks for the info. The pump is located in the bilge and I located the pathway behind cup holder. I have found the Acc1 pigtail on my 4 previous s/r but cant find this one. My wiring diagram shows the Acc1 on the forward EIM and Acc2 on bilge EIM & operates the under platform lights. I cant find the actual wire pigtail or the wire color & number on the schematic. Is it possible s/r did not provide that wire? Can I open the EIM and connect the wire to the Acc1 breaker??If I understand you correctly, you shouldn’t need to run a wire from your bilge to the helm for the ACC1 switch to control your wash down pump. Assuming your pump is in the bilge, the aft EIM is also in the bilge and the ACC1 wire will be right there based on the schematic. The helm switch panels connect directly to the EIM (aft or forward) with a couple wires already. However, if you do need to run a wire from the helm to the bilge, I’ve done it by removing the plastic panel with the built in cup holder. This panel is on the starboard side at the helm, down by your right knee. Once you remove about 6 screws around the edge, that panel comes out and you can reach forward to get wires under the helm. You can also reach aft to an opening which allows you to fish wires down to the bilge above the batteries.
Hope this helps. If not, just let me know.
Tom
Thank you again, Pat