Today when I replaced my bilge pump switch (because it was sticking) I removed the 3 screws holding it down. When I removed it, water started gushing out of the screw holes. ( boat is on the trailer)
Wtf? Anyone here experience this? It eventually stopped but still curious how water can get in...
So my 270 2007 slx with 496 engine overheat alarm is going off. But my running temp after a cruise at 3000 rpm’s is about 174 degrees. I turn the boat off and turn it back on and it “resets” the smart craft and I can get to my destination without any more alarms. I have already changed the temp...
So My mercruiser 496 has been overheating a bit. Changed impeller, bacflushed oil cooler, checked riser hoses, changed out coolant and inspected other hoses.
The last thing I did now was clean the heat exchanger. Pulled off the end caps and found that it was clogged about 15%, cleaned It out...
So I had a leak in the raw water pump which sprayed salt water on front part of engine. It mainly got on the other pulleys. Any pointers on how to remove the rust that it created.
remove belt, spray with what, clean up after with? don’t want to spend too much time on this.
Yes I already fixed...
Has anyone here when changing out the impeller, have the groove marks on the housing? What was your fix besides getting a new one.
I’ve seen wear plates for sale and was wondering if anyone just took the housing to a local machine shop and resurface the area where the impeller rubs and what was...
Good day all. Im having my smart craft overheat warning beeping and it shuts down the boat to neutral automatically.
before I was having a water temp sensor fault. So I changed it. Also a water pressure sensor fault. So I changed that too. All faults gone and now I’m getting the overheat fault...
So I’m getting a water temp sensor error code on the smart craft. Boat still runs but idle speed only. A couple of times I got it up to 29 mph. But then it shut down.
Idle speed only the rest of the time.
Will just the sensor cause this problem or is my impeller failing. Temp reading 176-189...
So before I bought my used boat, the prop shaft seal was leaking. The dealer agreed to change it before I purchased.
5 months later it started leaking again for 2 weeks. Last week I added more oil and today I took a look and it stoped leaking?
Any ideas as to why it stopped leaking all of a...
getting lost engine com error.
Then I smelled burning. Found out this part has a short of some sort. Right behind the steering wheel. Apparently the harness hooks up to the junction box of smartcraft. Anyone know what this is? So I can order a new one. Are they know to short out?