Search results

I have two of the interior door handles that have broken springs inside the mechanism. The result is the door handle remains down and therefore will not latch. I ordered two new handles through my local Sea Ray rep 9 months ago and I'm just getting the same story that they're waiting for...

Thanks for the input. I've checked all fuses and they appear to be in working order. The DC AMP & DC Volt meters on the chargers show no activity even with a large load running. Power switch light is on and all battery connector were replaced and tightened. Looks like I'll have to replace...

I have a bad charger for my port side batteries and need to replace it. Does anyone have any knowledge and/experience in tackling this unit?

I had the same issue two weeks ago. Most likely your problem is in the connector at the end of your power cord because that is what receives the most stress as you tug and pull it around. if you open the end of the cord up (two or three small screws) and expose the wiring harness you will...

After a late launch this season I had the unfortunate joy of finding my Sub Zero frig unit wasn't cooling. Light is on so I have power, but it's not cooling. What are the odds on this unit from my yr 2000 boat just needing a freon charge? Or am I most likely looking at a new unit?

Does anybody know a phone number to call Sea Ray at to ask this kind of question re: removing the salon floor and lifting the engine out?

I'm putting as many feelers out now as I can. I'll be limping her up to Muskegon for dry dock in the warehouse I normally store in next week and we'll start setting up for repair however we need to do it. I've never had to put the boat away this early...:(

They probably don't. I think I've been under too much stress lately... My boat is actually a 2000 560DB. I just spoke with a CAT mechanic who thinks they may be able to build some kind of "crib" to pull out the the cylinder, but it would take considerable labor hours to accomplish. So, now I...

I have just been informed that my #3 cylinder has either been scourched or the seals are bad and the engine has to come out in order to make this repair. How do they get the engine out of a 2000 540DB with 3406 CAT engines?:smt021