ok I know I have read this issue on here somewhere, ad I cant seem to find it but I need to replace my tank on my tilt trim pump. I haven't been out in a while and noticed it leaking,so my question is it just a swap an go, as I know there has to be certain pressure for the up an down, both being...
im redoing all the funstuff :smt038,gimble bearing, bellows shift cable trim sender, like I said the fun stuff but the new gimble bearing I received does not have the grease hole in it, I have heard of the sealed type but wouldn't it be better to have one you could grease regularly ??
ok, I started a new thread from a previous problem when I had a bellow leaking, and decided to change out some old parts for some new stuff and have opened a hornets nest I think! so while tracing down wires to trim limit I found that shifter cable is frayed, was supposed to new last yr from...
I recently moved from Tennessee, to Florida, what do I need to do In terms of making sure my boat stays mechanically sound and keep the salty elements from deteriorating stuff,,
Ok I have a 88 sorrento with an alpha 1 and was out last weekend and had an ignition problem, replaced the coil and while out on the lake I was having a flooding issue as well, so once I got it running again I noticed while having the sun deck up that a small hole right above the shaft coming...
I am assuming that I need to pull the riser and manifold to remove starter
adjusted my shift cable and seem the went bad when I tried to start it to make sure I did it correctly
Just did a shift shaft seal and Impellor change, finally got time to put on muffs before heading out tomorrow, not gonna happen
have a grunt type sound when I am engagedthe in forward gear with a little throttle and a tinging sound when trying to put it into forward gear
OH WHAT DID I DO...
as I'm waiting for the next day to come to get additional parts for impeller replacement I thought I would do some routine maintenance on the ole girl, checking fluid I noticed power steering fluid was gone.... Yes empty, not sure where but looked in bilge and there is some fluid in there but...
Is the MR and Alpha the same? the manual I bought is #6 which shows on the front R MR and Alpha, MR and ALPHA are dated from '84-90 in mercstuff.com as the same out drive??
Is the MR and Alpha the same? the manual I bought is #6 which shows on the front R MR and Alpha, MR and ALPHA are dated from '84-90 in mercstuff.com as the same out drive??
i have searched threads and couldnt find anything on this but, i noticed lube dripping from weep hole on on my lower unit. i have read up on it alot :smt024 just looking for some info or experiences with this issue and any special tools i need for the seal removal? new to actually working on...
Scraped the keel of my 88 sorrento on trailer because I made a newbie mistake and didn't have it in the water deep enough, plus I found out I was missing a roller
scrape flattened the keel for about 9 inches, live in middle Tennessee, looking for a shop to take it to, any help would be appreciated