Search results

  1. CRUZ'N

    THUNDER ON THE NARROWS - Md

    FYI ... Chesapeake Bay - Kent Narrows 24 th annual power boat races Jun 21-22. Races start at 1200 each day with various classes racing throughout the afternoon. Races will take place in Prospect Bay, South of Kent Narrows. Beautiful WX forecasted... see you there !!!! Tim
  2. CRUZ'N

    Great Bridge Lock, Va Closure

    FYI, For " snow birds ", the Lock closed Tues 11/05/13 due to valve failure on North entry gates. While repairs are being made, there are limited openings, conditions permitting......low tide, wind direction and speeds. The interim openings, using the South gates only, are set up for two...
  3. CRUZ'N

    St Michaels Oysterfest Nov 2, 2013

    Any upper Chesapeake Bay boats going to St Mikes this W/E. It's going to be a bit breezy, but otherwise good WX. I'll be there if your coming by boat or land...Stop by....Tim
  4. CRUZ'N

    65' Viking Sunk at Osprey Marina SC

    A friend text me Southbound on the ICW this morning. He pulls into Opsrey Marina to see a lot of official people running around. Apparently, a couple guys woke up to water lapping at their bunks !! They were taking a "SANDY" boat to Fl. They had a couple of 250 hp Yamaha's rigged up " on the...
  5. CRUZ'N

    60 DA Makeover

    Well.... Almost through, Prop Speed hardware next week, install eng props, thruster props (4), zincs (12), final coat of bottom paint, eng rm detailing, install TV upgrades, etc,etc,etc... Tim
  6. CRUZ'N

    Heads up chesapeake & delmarva

    This could be nasty AKA : June 2012
  7. CRUZ'N

    Valve Cover Plating

    4 of the 20 valve covers had varying degree of deterioration. After 7 wks they arrived yesterday. Before & after pics. After close inspection, I'd rate them a 9.5 I believe it was the best value though.
  8. CRUZ'N

    Searay navigator battery replacement

    Symptom : One of two Searay Navigators would display " reset clock " on power-up. Challenge : FIND and replace internal battery Apologies if pics are out of focus... 1) remove cables from back of Navigator 2) remove two small 3/4 X 3/4 emblems at bottom of Navigator bezel to reveal mounting...
  9. CRUZ'N

    SeaLand Vacuflush

    FYI : Though both head vacuflush systems were working fine, one was making a " banging " noise after each flush. After disassembling, all appeared to be normal. Further investigation revealed excessive " lash " in the gears of the motor shaft. The bellows and associated parts were normal,but I...
Back
Top