I currently have a RL70 and want to upgrade to color so I am looking for a used one to purchase if anyone has one they would sell. I am also looking on Ebay.
Thank you
I was told today that there is a correct way to install the duo props on my Bravo 3 outdrives for the best horsepower, torque, and fuel efficiency. I was a little surprised but I thought I would ask.
Can someone please fill me in on whether this is true or not? And if it is, what IS the correct...
I have a 1999 310 Sundancer with a Raymarine ST5000+ Autopilot. It has been working great but this weekend it would not engage. The instrument display looks normal, the display shows it go from standby to auto, but it does not take over. Any ideas??
Has anyone ever had this problem?
When under power, at any rpm, my port engine alarm sounds intermittently, and sometimes the engine hesitates for a split second. It almost seems like the engine misses, and tells the alarm to sound, but it literally happens for a split second. No gauges drop or...
My question is regarding the use of dockside water. I have onboard water and it is obviously pumped with the water pump throughout the boat system. When I connect the dockside water hose to the inlet in the transom trunk, the faucets on cold don't work unless the water pump is switched on...
Can anyone tell me what is the best length of chain for my 310 DA? I have a winless and the book says it comes with 125' of 5/16 galvanized. I currently have a Chain leeder with rope after that and want to make it all chain. Is it recommended I do so? If so, how long?
Thanks
I am looking for:
1. G623759-4 RAY210 VHF Radio Sun Cover
2. D331 RL70 7" Pathfinder Sun Cover
I have looked everywhere including Raymarine (who say they are no longer available). Anyone know where to find these?
My tabs are fully extended and won't retract. The reservoir pump is full to the line, I just installed new batteries and they show full 12+ volts. I can hear the motor run loud in one direction, and weak in the other direction (up/down). I assume weak on the down because they are extended. Any...
Is it necessary to replace the nylon insert brass 7/16-20 nuts on the stainless pivot pins that hold the trim cylinders on or can they be stainless or zinc? Must they be brass? Cannot find them anywhere.
I removed the outdrive on my Bravo 3 Merc on my 310 Sundancer and need some help determining if I need to replace the drive coupler in the engine. My real question is, what is an acceptable wear level on the shaft splines and is it possible to replace the shaft and not the coupler on the engine...
I need to buy all new lines for my 310 sundancer. Can you all please advise on the following?
-How many?
-What size diameter? 1/2", 5/8" etc.
-What lenght? 15', 20', 25' etc
Thank you!
I removed all the hardware and all the caulk from every seam on my 310 Sundancer before I refurbished it. I now need to recaulk everything, inside the cockpit and out including the rub rail top and bottom. I will be remounting stainless hardware as well. What white caulk and sealant do you all...
Can someone recommend batteries for my 310? I need 2 for the boat and 2 for the inverter (they are connected in series but separate. So, the "boat" has one starting and one deep cycle, the inverter has two batteries. This doesn't mean it is correct, just looking for advice on buying 4 new ones...
Has anyone ever painted cup holders, radome covers, antennas, etc to restore the whiteness after sunfading? What is the BEST plastic paint?
Thanks for the advice.
Btw, used the 925 wax last week, awesome stuff, thanks.
I just stripped and buffed my boat and need to reapply wax. Can anyone recommend a good wax to put back on? Freshwater boat, 99 310 Sea Ray Sundancer.
Thanks!
Does anyone have or know where to get an 18" Radome Cover? The W101 model at Raymarine is out of stock and unavailable. I would be happy with a used one.
Thank you