Search results

  1. Jetmart

    Black spots in diamond pattern non-skid

    Can you let us know how it works? What strength you use, etc.
  2. Jetmart

    Stern Anchor Size?

    How is the fortress on a rock bottom?
  3. Jetmart

    Stern Anchor Size?

    I have a 37' cruiser and looking for recommendations on size of anchor for stern to prevent swing when spending the night on the hook. Planning a trip to the North Channel.
  4. Jetmart

    How important is RADAR?

    Never had it until this boat. Would not want to go back not having it.
  5. Jetmart

    Sanding Nuteak or Flexiteek?

    Thanks, I saved a small area using a sanding block. I was surprised how uneven the swim platform actually was. It lightened it up a fair bit but I glad to hear it will darken up quickly. I have more to do but wanted to see how this area turns out.
  6. Jetmart

    Sanding Nuteak or Flexiteek?

    Has anyone sanded to remove stains? I have boat polish that got on it and no amount of washing with a pressure washer has removed it. The manufacturer recommends sanding it. Has anyone tried it and how were the results?
  7. Jetmart

    Anyone Install A Raymarine EV-200 Auto Pilot?

    Looking for feedback or any suggestions with the install. Where did you locate EV-1 Attitude Heading Reference Sensor (AHRS)? It must be kept away from the compass and the electrical components to prevent interference.
  8. Jetmart

    Boat Carpet Snaps

    Unfortunately I don't remember the shade #.
  9. Jetmart

    Boat Carpet Snaps

    We love ours. Got it last season.
  10. Jetmart

    That was a fun day

    You should have checked the alignment with an alignment tool before you pulled the bearing. This way you know the engine is aligned with the old bearing. After installing the new bearing you may need the tool to adjust the "eye socket swivel" of the bearing to line up. Once you know that the...
  11. Jetmart

    gimbal bearing replacement issues

    Thanks that is helpful. I have a Volvo drive an the bearing is in much further then on a Merc. I just don't know how I am going to line up the grease hole with the grease fitting. I have a alignment tool with a bearing driver but not sure how I am going to make sure the bearing doesn't turn...
  12. Jetmart

    gimbal bearing replacement issues

    I would appreciate pictures and directions for installing.
  13. Jetmart

    Radar overlay on c80 and seatalk heading compass

    I have a 2004 C80 with radar and was told one of the software updates remove the overlay option. My manual said it was doable and it drove me crazy trying to figure it out.
  14. Jetmart

    Evolution Autopilots

    Thanks for the info. Did you install it after market or did it come with the boat? What type of steering do you have and what part of the steering system is the autopilot driving?
  15. Jetmart

    Evolution Autopilots

    Looking to put in a Raymarine Evolution auto pilot in. Does anyone have one that could comment on how well it works, was it an after market install, was it difficult to install, how well does it work etc.? Has anyone hooked it to a C80?
  16. Jetmart

    A/C Evaporator filter Location on 2006 Sundancer 290

    Anyone? I am looking at how to get to and where the air conditioner air filter is. There should be a pre-filter before the air conditioner coil.
  17. Jetmart

    A/C Evaporator filter Location on 2006 Sundancer 290

    Where is the location of the evaporator pre filter on a 290? How do you get to it?
  18. Jetmart

    Kohler 5E generator / A/C problem?

    "If not then you need to check the governor or regulator." What is there to check on the governor? My generator seems to be varying a bit on speed as it gets warm. I am suspecting the governor.
  19. Jetmart

    Cal Marine Pumps

    I put a March on tonight
  20. Jetmart

    auto pilot for 2005 Sundancer 340 with twin sterndrive BravoIII

    What do you use to interface with the R?
Back
Top