Search results

Hi all, My marina just completed bellows and steering pins on my 2004 300 sundancer with bravo 3 drives. They launched the boat and when I started it up to go out for the first time I noticed that the starboard drive was in gear. When I shifted forward and reverse, the drive did not go into...

Does anyone know if Royce Fuel Senders are still manufactured? I'm unable to find a web site on the web. My fuel sender is reading empty however my tank is 7/8 full. Posts suggest the float may be saturated and sunk to the bottom.

I have twin 5.0L MPI engines. Normally both engines runs at 150 degrees at idle and 160 degrees while running on plane. The port engine is now running cold 120-130 degrees when not on plane. When on plane it very slowly increqdes to 160 and falls quickly when throttles are backed off. The...

Hi, I have a 2004 300 Sundancer with twin 5.0L with B3. Last fall, my marina reported one of the engines were out of alignment. The good news is they didn't find any wear so I just need the engine re-aligned. My marina has a habit of billing more time than it takes for each repair so I'm...

Has anyone experienced problems with losing the gps fix when the mic is qued? I purchased and installed an A50D in place of the old unit. The same positive and negative wires were used and the drain wire was grounded. The unit is installed on a 2004 300 Sundancer and I'm using the internal...

I had my marina pull the drives on my 2004 300 Sundancer since this was our first season with this boat. They reported the following: - Port side insert for trim adjustment missing. - Starboard engine alignment is out. - Coupler splines dry and showing signs of wear - Both Gimbal bearings...

Can anyone tell me how to winterize a Kohler 5kw generator? I couldn't seem to find and thing using the search tool. I know the generator is cooled by fresh water but it also has a closed cooling side as well. Do you fog the generator same as a small outboard (through the carb?). Do you...

I recently had starboard engine trouble. My marina found two codes - high water temp and IAC (idle air control). I believe the high water temp code was an old code since my smart craft gauges showed proper water flow but since it was our first year with the boat, I decided to have the marina...

Hello, I just purchased a 2004 300 Sundancer with Twin 5.0L's and Bravo 3 drives. The boat is equiped with smart craft gauges. Any help you all can provide on my speedo and trim problems would be appreciated. First, the speedo does not work at all. I looked under the dash and its all...

Hello, I'm in the process of purchasing a 2004 300 Sundancer. While I was looking over the generator (Kohler 5kw), I noticed it has an antifreeze tank that I would assume is for cooling the generator. If this is for cooling, does it use lake water as well? What would it need to be...

I am looking at a 2004 300 Sundancer and it has an electric engine hatch. I'm guessing the batteries were disconnected for the winter since switching the batteries on and turning on the main panel didn't work. Is their a bypass somewhere? The engine hatch is still connected to the ramp so it...

I looking at a 2004 Sea Ray Sundancer with twin 5.0 Mercuiser Engines with Brave 3 Drives. They made this boat from at least 2002-2006. The boat came with three gas engine options, 5.0 (260 hp), 5.7 (300 hp) and 5.7 (320 hp). Can anyone comment on the performance of this boat with the 5.0...