Hi all,
My marina just completed bellows and steering pins on my 2004 300 sundancer with bravo 3 drives. They launched the boat and when I started it up to go out for the first time I noticed that the starboard drive was in gear. When I shifted forward and reverse, the drive did not go into...
Does anyone know if Royce Fuel Senders are still manufactured? I'm unable to find a web site on the web. My fuel sender is reading empty however my tank is 7/8 full. Posts suggest the float may be saturated and sunk to the bottom.
JimFromMD, I do have smart craft gauges and will Check the readings. I'll be out of WiFi and cell range for the balance of the week but will get back to you later in the week.
The thermostat was my first guess. Both were changed a few years ago and the problem persisted intermittently. Maybe...
I have twin 5.0L MPI engines. Normally both engines runs at 150 degrees at idle and 160 degrees while running on plane. The port engine is now running cold 120-130 degrees when not on plane. When on plane it very slowly increqdes to 160 and falls quickly when throttles are backed off. The...
Hi fellow 300 owners
I purchased a tablet to use as a backup chart plotter. Was wondering if any of you have done the same. Can give me your opinion on how/where you mounted it.
Thanks
My Progressive Dynamics PD2030 charger/converter is not working. Has anyone changed their charger? If so, what did you replace it with? I've having trouble locating a dealer in Canada for Progressive Dynamics products.
Can anyone who has the battery adapter that plugs into the DC socket at the helm tell me if the adapter has a fuse and what amp the fuse is. The picture put on this thread as few weeks ago doesn't show a fuse however some of the new adapters have them inside the DC adapter.
Thanks
My boat didn't come with the battery adapter that plugs into the DC socket at the helm either. Anyone know the gauge of wire SR used so I can make an adapter?
Thanks
I had a transom leak on my 89 250 Sundancer and the marina pulled the motor and replaced the transom seal and bolts. I've never heard of any other way.
Anyone have to replace the microwave in the 2002-2007 300 Sundancer? Mine went kaput this weekend and I'm having a heck of a time finding one that fits the dimension of the old one. They are all 1/4 - 1/2 too tall even without the spacer. Any ideas would be appreciated. I'm hoping not to...
I owned a 1989 250 Sundancer with a 350 (260 hp) for 7 years and loved the boat and I had a few friends that had 268 Sundancers. I preferred the 250 since the forward berth was 6 ft long so sleeping was a breeze. It was just me and my wife so converting the forward birth to a table once and...
Hi Jkim 1990
I have the marina winterize the engines (I havn't been brave enough to winterize the engines) but my marina tells me they do use some cocktail. Either way the fogging oil should burn off in no time. I've never experienced any problems with fouled plugs on any of my boats after...