Blown284
Well-Known Member
Anyone here add the ability to turn on/off the boat's a/c via wifi? If so, what did you use?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Any one can tell me what group starting battery we have in the 460.
I should know this but dont
Thanks for the help.
Factory spec for my '02 put the following: 8D port engine and house, and 8D starboard engine and house/electronics, but I cannot remember the amp hour rating. Genny starting battery is a 27 group. 24V system for thruster and GHS platform uses two 31 group 12V starting batteries in series.Any one can tell me what group starting battery we have in the 460.
I should know this but dont
Thanks for the help.
Nice canvas job!
Any one can tell me what group starting battery we have in the 460.
I should know this but dont
Thanks for the help.
Took boat out last weekend. Noticed my running lights on bow wouldn't come on (port and STB) with everything else. I am assuming a contact issue since it was both. I was going to run back up today and take them apart. Anyone have any advice on this before? I usually just check before I do anything now due to the great advice on Here. thanks!
It should be behind the steering wheel. Open the hatch under the steering wheel and look up on the panel of electronic stuff. IE autopilot brains etc.Getting ready to install new stereo equipment in my 2003. Where is the factory amp? I have been told it is in the dash? Looking for suggestions for a better place to install the replacement amps. Any thoughts?
https://www.fpmarine.com/category-s/1757.htmAnyone here happen to know a place that creates panels for the dash other than Technografix (who has a backlog of 6+ weeks).
It should be behind the steering wheel. Open the hatch under the steering wheel and look up on the panel of electronic stuff. IE autopilot brains etc.
I replaced mine and put the new JL 800 x 8 in the same spot. It was easier because the speaker wiring was already there and there are very good ground and power terminals to connect to. Although I did run new wire to some new speakers, it was the logical place for the new amp. The 2nd amplifier I installed was placed behind the chartplotter panel to the left of the helm. There is A LOT of room behind that panel to place an array of items.
The bow pad on the 460 is pretty generic, It is time to update ours.
Have any of you with the older searay updated so the top part of the pads tilts up like the newer boats to make it a lounger also did you go with a new design?
Post pics!