Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
On mine when in the full up position (where the trim limit would be not the trailer position) the gauge is at ¾ of the way up.
My question is when you are trimmed all the way up/out should the gauge needle be all the way to the top, in the "Up" position? or is this postion to indicate the "trailered" positon?
Thanks Guys.
I got the wires spliced and everything seems to be operating correctly. I found this link below that appears to give me the correct measurement as to where the trim limit switch would have kicked in (had trouble finding the measurement in the Mercruiser Installation manual I found online). So if I understand this correctly I should raise the trim until I reach the point where the measurement on the cylinders reaches 21 ¾ inch (I believe my 1995 alpha is considered the earlier model). Once there, mark that on the trim gauge as the highest point the drive should be trimmed up while the boat is in gear.