Official 380 Thread

Mauler34Rod said:
Correct, according to the invoice I paid.
Click to expand...
You might want to check that. It should be replaced annually if you use it at all. Mine was 1/2 to 3/4 gone at the end of last season and I only probably used it 30-35 hours.
 
SCFoster said:
TTMOTT to the rescue. Appears that with the fire extinguisher not installed, the blowers will not operate.



I'll have to install the new fire extinguisher bottle and see if that solves the 'problem'.
Click to expand...

Hooked up the old fire extinguisher and the blowers fired right up. Mystery solved.

However, the helm blower switch doesn't seem to work. I can turn them on/off using the Salon power panel switch, the helm switch has no effect at all. That's a longer term to-do list item.
 
mrsrobinson said:
The fuel capacity spec for my 2001 380 is 275 gallons. I assume that's diesel or gas? Is that 137.5 gallons in each tank?

I will be doing a shock to my tanks hoping to alleviate a suspected algae problem. I need to know approximately how much of each treatment to put in.
Click to expand...

Close...Parts Manual for the '01 380 is 143 gal each.

upload_2023-6-18_11-2-17.png
 
mratlndmrk said:
You might want to check that. It should be replaced annually if you use it at all. Mine was 1/2 to 3/4 gone at the end of last season and I only probably used it 30-35 hours.
Click to expand...
We’re in freshwater, so not needed annually.
 
Hey Chris did you ever fix your speed? I am using the og analog transducers. Mine worked but I got stuck shallow last summer and it never worked since. there is one forward and one in the back, do you know which one?

Thx.

Chris-380 said:
Mine doesn’t read speed either. Guessing I need to clean the wheel…
The transducers(2) are in the center of the bilge near the fire wall. With each transducer should be the plug, if you were to need to pull the transducer out for service, you can plug it with the cylinder that is attached to it. I haven’t seriously thought of pulling it to service….
Click to expand...
 
I haven’t pulled mine, don’t know which is which, but iiirc, mine are side by side. My buddy has a 2001, his were the same as mine.
tdb380Ray said:
Hey Chris did you ever fix your speed? I am using the og analog transducers. Mine worked but I got stuck shallow last summer and it never worked since. there is one forward and one in the back, do you know which one?

Thx.
Click to expand...
 
The port refrigerator as well as the port electrical outlet stopped working on my boat after they hauled it out to paint the bottom. Any chance they flip the switch or did something I'm not aware of? Anything else I should check?
 
Which port receptacle?

mrsrobinson said:
The port refrigerator as well as the port electrical outlet stopped working on my boat after they hauled it out to paint the bottom. Any chance they flip the switch or did something I'm not aware of? Anything else I should check?
Click to expand...
 
Thanks, I was not aware of that, very helpful.. Reset them, same result, cockpit one doesn't work.
 
FREE canvas, appears to be original to the boat, I don't know where these go, but it has black canvas now so I don't need it. Pay shipping cost and it's yours.


PXL_20230703_192501957.MP.jpg
PXL_20230703_192445645.MP.jpg
PXL_20230703_192431994.jpg
 
Chris-380 said:
The bottom one, is that a carpet runner of some type? I just can’t figure out where either of theee go
Click to expand...
Yeah I'm not sure where they go either, they were on the boat when I bought it, they look original from the factory.
 
You must log in or register to reply here.

Forum statistics

Threads
113,186
Messages
1,428,197
Members
61,098
Latest member
Klawson83
Back
Top