PlayDate
Well-Known Member
You need to pull out your DVM and check the voltage on the Glow Plugs when someone else hits the Preheat switch. That will confirm you are getting voltage and what the voltage is. Your unit uses a solenoid for the glow plugs. Page 36 of the manual, top of the page. It is a 12 VDC system.
If you don't have voltage then you have to move further back up the circuit to the relays.
Again with a helper it is easy to check the actuation and the voltage at the relays.
Make sure the remote Stop switch is not resting in the Stop position.
If you don't have voltage then you have to move further back up the circuit to the relays.
Again with a helper it is easy to check the actuation and the voltage at the relays.
Make sure the remote Stop switch is not resting in the Stop position.