Now that I've transitioned from a twin engine wide beam to a single engine narrower beam, I notice how sensitive to weight changing the boat can be. With the addition of factory A/C and Vaccuflush option, both mounted on the port side, I notice that the boat lists a few inches to port at rest. This is something that was never a concern with the 300DA. It does bother me and in addition the bottom paint line is now about an inch below the water. With no way to shift any weight around it's clear that the only solution is to add some weight to the starboard side to balance it. It loks like 150# should be perfect. Has anyone else had this issue? How did you resolve it? I'm looking into obtaining some lead bricks, about 25# each, they are not cheap (about $50 per), but they give me the most weight per area. Any comments or ideas?