Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
I will Try to explain as I don't have close ups as of yet. It has 4pcs. 12 inch aluminum I beams going across underneath wich have 2inches of Juniper wood for cushion on each one. they rest directly on the bottom (2 near the rear sling point and 2 in the front) Most all the weight is on the centers of these I beams except the aft end. The total bend calculated to 1inch of deflection. I set it up so that there are outboard supports that let the outer edges of the beam set on blocks after there is 1/2inch of bend in the beams. I still have most of the weight in the center. On each end of all 4 beams 3/4" cables go up around pulleys and are raised by the hydraulic cylinders. I do have drawings for all of this but there are quite a few. If anyone is really interested I will get more detail and show with close up pics. I did not think anyone would have that much interest on how it was made. Thanks for the compliments though!