ZZ13
Well-Known Member
Can you post pictures of exactly the area you are referencing.Public Information Notice:
So in correcting my fresh water leak from my failed master head shower fittings, this is what I found out...the water that leaked from the master head shower fittings located behind the galley fridge ( and I would suspect it might be the same from a possible leak in the galley sink fittings ) does not immediately find its way to the forward sump/bilge area, as you would expect. Nor can it flow back to the aft bilge area in the ER due to the engine room bulkhead. Instead, it flows into a hidden, non accessible space just aft of the galley floor hold where it steps up next to the rear AC unit. My water collected in there until the level came up high enough (at least 6-8") before spilling over into the rear of the fwd sump/bilge area next to the bilge pump, through a small access hole cut to accommodate the galley sink water lines after they tee off from the main lines in the fwd bilge area. Not an optimal design in my opinion. I sucked and siphoned about 3-4 gallons of water through that small access hole which would have sat and sloshed around in there until it evaporated, which who knows how long that would of taken. Has anyone accessed that area by cutting an access hole they might want to share?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk