On mine you unzip and unsnap the front bimini canvas from the arch. Then you fold the canvas around the the upper part of the frame then put the cover over it. The frame stays in place without folding it. The rear bimini is similar except the aft section just needs to be unzipped from the small section of the bimini that is attached to the arch. Again, no folding of the aft bimini poles is required. (In looking at the picture of your boat it does not appear you have the rear bimini top or rear camper canvas........only a slant back canvas...... for yours. If that's the case you can only fold your front bimini. You likely either have to leave that rear bimini in place or take it completely down.)
If you are missing the covers, you can order them directly from http://www.greatlakesboattop.com/ at a substantial discount compared to ordering them thru your dealer.
The entire canvas installation guide is also available for downloading on Sea Ray's web site (just beware this a 34KB file) http://www.searay.com/boat_graphics/electronic_brochure/company1729/1C1_51_74DEXLTCJ008.pdf
and that may help explain a few things as well.
Dave
If you are missing the covers, you can order them directly from http://www.greatlakesboattop.com/ at a substantial discount compared to ordering them thru your dealer.
The entire canvas installation guide is also available for downloading on Sea Ray's web site (just beware this a 34KB file) http://www.searay.com/boat_graphics/electronic_brochure/company1729/1C1_51_74DEXLTCJ008.pdf
and that may help explain a few things as well.
Dave
Last edited: