Kendall
Last Activity:
Feb 15, 2018 at 12:35 PM
Joined:
Feb 3, 2009
Messages:
365
Likes Received:
1
Trophy Points:
18
Location:
Lake Wylie SC/SC Coast
Occupation:
Engineer

Share This Page

Kendall

Member, from Lake Wylie SC/SC Coast

Kendall was last seen:
Feb 15, 2018 at 12:35 PM
    1. Kendall
      Kendall
      Hi Rick:

      I assume you are talking about removing all the vinyl padding overhead in the aft cabin? I did not have to do this as I just removed the port seating cushions and ran cables down the side of the boat from the stereo area. I then went into the engine area from behind the sink area, across the bulkhead and back into the starboard cabin area. I removed the helm pocket and could reach back into the void area. You may have to drill a hole through one of the support stringers on the starboard side. I hope this helps.

      Kendall
    2. Rick1503
      Rick1503
      Hi, I'm trying to install a new stereo in my 260 and I cannot figure out how to disassemble the cabinet that holds the stereo and the power panel. The stereo I purchased requires a slightly larger hole and the remote cable is different so I need to run the new cable to the helm. If you removed this panel and cabinet I would appreciate any help you could provide. Pictures or video would be great. Sea Ray does a great job making their interior look clean but it sure is a pain to try and figure out how to disassemble it.
      Thanks, Rick
  • Loading...
  • Loading...
  • About

    Location:
    Lake Wylie SC/SC Coast
    Occupation:
    Engineer
    Boat Info:
    2006 260DA
    "WET BAR"
    Generator

    Tow Vehicle:
    2006 F-350 Dually 4X4 Diesel
    Boat Brand:
    Sea Ray
    Engines:
    350 MAG w/Bravo III
    Boating, Skiing

    Signature

    2006 260 DA
    350 MAG B3
    "WET BAR"
Show Sidebar