My temperature sensor is reading high on my Cruisair SLXR16-N9 HVAC system. I ordered a new sensor and it came with an RJ11 connector. My system has a 3 pin plug. I looked online and there are places that sell the adapter to go from RJ11 to 3 prong plug for over $100. Does anyone have the...
Is there a way to set the SMXII to just dehumidification mode while I'm away? I've tried a couple of things and keep getting dehumid followed by cool/heat with 1.5 temp difference.
Hello - I recently had all of my batteries replaced on my 2014 330 Sundancer and now my Cruisair thermostat is flashing between "15" (or "IS") and "--". I believe the display is a Q-Logic Qht Kaypad/display. I've looked at the QHT manual and it mentions an inside temperature sensor failure but...
Seems my seawater pump for my 12,000 BTU cruisair split ac system (condenser and pump in the bilge) has crapped out (electrical short between neg and pos)
all the numbers are worn off the pump (which I think is orgininal) and trying to find a replacement, but don't have any manuals or other...
Hi Everyone,
The Ft Lauderdale Boat Show is quickly approaching. Not everyone makes it to these events (this guy will be a two car shows with my nonprofit) SO EVERYTHING IS ON SALE 25% OFF!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!. From now til 11/15/14 I will take any order through...
A marine technician my marina sent to recharge my Salon A/C said that I 'may' have to either repair or replace my unit instead. Surprising since my A/C units on my old '93 400EX are original and still work great and my 420DA is an '05.
He's quoted $2,500 for compressor and reversing valve...
I am looking for advice where the control box is located holding the 3 cruisair trigger switches on my 2006 Sundancer 40. The front state room AC won't activate the water pump relay.
I did a search at the forum and found a thread which indicates this control box is behind the main distribution...
The Cruisair unit on my 2006 Sundancer 260 is suddenly making an incredibly loud noise when it cycles to "heating". No errors are displayed on the control module and the heating function works well. All other cycles purr nicely - no problem. I've cleaned the filter and looked for PDF service...
I see some discussion of error codes that show up on Cruisair SMX panels but didn't find an answer to my issue. I have two systems onboard with a single water intake and two water thru-hulls, one for each unit. A year or so, one unit started displaying PS/LO. Water seems to be moving fine and...