Search results

This is an old 1985 Mid Cabin Cruiser. It started taking on water while riding, filling the reservoir up front at the bottom of the steps. I removed the cover to visualize it and the bilge works fine fortunately! I assume water is coming in through the hull in one or more fine cracks...

I have just spent $1800 getting her ready for a great summer (not bad for investing over several years) that is what happens when you let them set up for 2 years! Anyhow, wondering how to repair or replace the glass aluminum frame (there is no glass in this part of it) that goes back toward the...

Good evening, This summer my shifter did not work until I lowered the unit to cruise level. I just cranked her up with a water hose and the same thing, runs great but will not shift any direction other than I can pull her to neutral, outdrive up or down. I removed the connections at the engine...

Broke the right side windo frame, the one that runs from the front to the mid side of the boat. Anyone know where I can locate one or both sides? Thanks, Glenn glennj3cub@bellsouth.net

Looking for advice on where to start. While cruzing last Saturday the engine RPM shot up and the boat stopped going forward. I immediately idled back. She would not go into gear nor make any shiftin noise (moving the throttle forward or back was smooth, no grinding). There was no unusual smells...

I have the 170 MC, drove out last Saturday for several minutes when she stopped moving, I thought I lost the prop. The engine RPM shot up, immediately pulled back to neutral. She would not go into forward or reverse. No unusual noise, smell, what so ever. After pulling her out, I put in forward...

I have the chrome spot light, ray line, 5 inch. I checked the servo motors and they all work fine if I connect 12 volts to them. The light comes on from the switch but the light will not rotate using the toggle switch. The toggle switch is sealed but does have connectors (terminals) on the...

I have an 1987 Sea Ray Seville Cruiser. The spot light stopped working. Found the ground was not good. The light comes on now, high and low beam. It will not turn any direction. The motors are good. Does anyone now how I can check the wire terminals on the toggle switch to see if they are good...