Search results

Here we go Sea Ray guru's, I am having a issue with the aluminum frame separating from the glass on the port side to the point that u can actually see between the glass and the frame, what is causing this and how do I fix this issue? Thanks

I am looking at a 1993 24' Sundancer that is up for auction. I am not real sure what all equipment is on the boat cause the listing is not real descriptive but from what I can see in the pics and what's listed it has a 305 inboard, kitchenette, bathroom, sink, refrig, rear shower, am/fm stereo...

Help please I have read all the posts about polishing and waxing and which products to use and there are so many different opinions on polishes and waxes to use. I have light oxidation on my boat and it just doesnt shine like it should, so I bought me the Harbor Freight polisher that was...

1 of my bunks on my 180's Shorelandr trailer is starting to break and needs replaced so I am gonna go ahead and do them both. My question is they appear to be 2x6's about 8 feet long with about a 6 foot or over span between the brackets would the new Composite Lumber work for this? If so I don't...

I am looking to move up to a bigger boat and I have found a couple of 92 230 Sundancers with the 4.3 engine and was just wondering how well this boat will perform with this engine setup? I am not looking to fly around the lake with it but I would like to be able to pull the kids on a tube and...

I have a 98 3.0 with around 350 hours on it and have been fighting with it not wanting to run right above 3800 rpms without missing and an occasional backfire. I have replaced the plugs, wires,distributor cap, rotor button with no change so from there I moved to the fuel system took the fuel...

I am looking to buy new wires for my 98 3.0 Mercruiser and I am a little confused, I do know that I have a Delco EST ignition system and most every website I look at have a price range of $45 to $50 for a set of wires except for one website I found that has a set for $18 but there is no year...

Having a missing issue with my 98 3.0, what its doing is starts and idles perfectly takes off and planes with no issues and will cruise at 25 or 30 mph with no problems but when you run it WOT it misses and backfires through the carb. Installed new plugs thinking this was the problem but it is...

Heres my question, In front of both the driver and passenger sides of my 1998 180 there is an area in the floor that goes up on an angle approximately 16 inches or so then flattens out for 5 or 6 inches or so which to me would be a footrest area, has anyone ever cut a hole in this area for say a...

On my 180 Bowrider the part that you can open and close is out of adjustment so its hard to open and to close does anyone know how to adjust this to make it open and close easier? Thanks

Heres my dilema I currently have a Toyota Tacoma 4x4 Extended cab that I currently use to tow my 1998 180 bowrider, but my family is outgrowing my truck so I am looking to upgrade to a Tundra with a V8 but the only good ones I can find in my price range are 2wd. Does anyone think I will have any...

I just recently aquired a 1998 180 Bowrider with a 3.0 Mercruiser and Alpha 1. It was a credit union repo so I didnt get any service records with it but there is only 209 hours on the clock.I have had 2 previous boats which were older and I was younger so I did very little maintenance on them (I...

Hi everyone, new to the site but not new to boating this is my third and my second Sea Ray,could not get away from the Sea Ray quality after owning one. I love these forums they are packed full of useful information and great people! Happy boating 2 all!