Search results

Does anyone have any SRV 240v emblems that they want to sell? I'm in the process of restoration. Mine are in really poor shape. These are the two emblems located on the rear port and starboard sides. Thanks folks...

I am looking for the black rubber molding that goes around the windshield and side glass. It's black and about 3/4 " wide. This molding goes on the outside of the glass around the outer edge (I'm assuming to help prevent water from getting down to the outer edge of the glass and possible coming...

Help me out here. My '77 240 OMC GM 350 with an Edelbrock 1413 four bbl. carb is acting up again. Took the boat out this morning (air temp 49 degree -brrr) and put it in the water to see if it did the same as yesterday (which it did). Ran the boat about 1 hour with absolutely no problems. Then I...

I am in need of a new mechanical fuel pump for my boat. I have a 1977 SVR 240 with a OMC GM 350 engine. There are so may simular types of fuel pumps, and I sure the look has changed since my old one was made. I think that the Sierra 18-7268 may be the replacement. Any help would be great folks.

Hey Folks. Hopes everyone is enjoying a trouble free year so far.. My good old '77 240 is not enjoying the heat.. I have a GM350 engine w/a edelbrock 4 bbl. carb. The carb does have the 1/2 riser to get it directly away from the engine. I have 2 louver vents; each on has two 3" vent lines...

I have a '77 240 SVX240 with a GM 350. The engine was rebuilt about 1.5 years ago and the carb. was also replaced with a new 4 barrel. The boat has run fine in the past until several month until I took it out on the bay. There was probably 3' swales when we launched and towards the end of the...

Does anyone have for sale or know where I can get a good bow pulpit for a 1977 240 Weekender... I looked into the metal track w/roller at the end, but doesn't seem long enough to stick out over the end and would need a wedge support. I am planing on install a windlass so I need a good pulpit...

Folks, I have a 1977 25' Sea Ray SVX240 w/ GM 350 engine. I would like to know if the instrument gauges sold by Overton's or another major marine store would match up with the old wiring (32 years old). I'm hoping to replace my spedo, tach, oil, water, trim, fuel, hour and volt gauges. Should I...

Hey Folks, I seen alot of discussion on other web pages about the type of oil to use in your engine during a oil change. I have a 1977 25' Sea Ray SVX240; Engine GM 350; Outdrive OMC 800 Sterndrive. Could someone explain to me if I should be using this expensive 25w-40 marine oil, or is a...

Does anyone have any ideas why my outdrive sometimes won't go up or down when I am ready to trailer the boat. When I hit the switch, it just clicks - nothing more. Usually after several attempts it finally works. Secondly, are there two grease fittings where the outdrive attach's to the stern...

I have reported several weeks ago that my 1977 25' Sea Ray SVX240 has horrible steering. After several responses (thank you all !!!) one person mentioned the Trim Fin. Upon investigtation of the drive, I noticed it has been broken off. That's the good news. The bad news is that I can't locate...

I have a 1977 25' Sea Ray SVX240 that is horrible to steer. I have the mechanical cable steering (according to the previous owner, was replaced 3-4 years ago). I have had my mechanic look over the boat and said the steering is fine. The boat has the 350 GM motor, with the stringer OMC outdrive...