Search results

  1. andy k

    Lake Erie MayFlies!! Questions from a newbie on lake Erie

    This is our fist year on Lake Erie and the Mayflies are Nasty. It is hard to go and enjoy the boat when you and the boat are covered so heavily is Flies. 1) Typically is there a strong bloom and then it becomes less dense for the summer or does it stay strong through summer? 2) Are they...
  2. andy k

    Raystown Lake in PA or .......

    I received a Job offer to work in PA. As it is a more remote type job I am able to live anywhere in PA. One of our big requirements is having a boat friendly area. We enjoy marina hopping but mostly enjoy throwing an anchor and finding a beach. Some areas that we were looking at are Raystown...
  3. andy k

    Cruisair SMX II Circuit Board

    I need Help! I have a Cruisair SMX II in my boat currently. Everything works great on the unit, However the keyboard flashes and the buttons don't work "most of the time". Currently the unit is stuck on the AC mode at 70 which is perfect for most the year. We are wanting to sell this boat...
  4. andy k

    1970's MAKO 19' Restoration

    I know this is not a Sea Ray. We wanted a smaller boat to cruise around on and hop between some different local lakes. I was originally looking for a small Sea Ray BR to fix up. Things changed when I came across a 1970's Mako 19' that needed a full restoration. This project was started by...
  5. andy k

    Upgrade Mercury 8hp to 9.9

    I can get a really good deal on a new 8HP mercury. What would be the part numbers that I need to change it from a 8HP to a 9.9? I know it is the carb but I cannot remember the other part that I need. I know the information on on this site, however I am struggling to find the information...
  6. andy k

    WEAVER DAVIT PIN REPLACEMENT HELP

    I have a set of weaver davits with the removable base as shown in this picture. I lost my pins and cannot get anyone at weaver industries to get back to me on the replacement of these pins. Would anyone be able to measure their pins to let me know the width so I can order new pins. I would...
  7. andy k

    Mississippi River / St Croix River

    We were planning on trailering the boat to the North Channel in Canada again this year. However do to this Virus I am thinking that things may be more complicated with traveling to Canada. So now we are looking to stay more local. We are either going to go the the Apostle Islands or run the...
  8. andy k

    WATER PAD / LILY PAD --- 3 Layer vs 2 Layer

    We are looking to pickup a Water pad / Lily pad for Christmas. What are your experiences with the different sizes and thicknesses of these? Any recommendations or experiences with these would be much appreciated. Thanks
  9. andy k

    Planning a trip to the Apostle Islands

    We are planning a trip to the Apostle Islands for next summer. I am have a hard time finding boating advise for this remote area. I was hoping that there would be some fellow boaters in this forum who have visited this area. This would be our first visit to this area. 1) We will be trailering...
  10. andy k

    North Channel

    Hello all, We will be leaving for our first visit to the North Channel in a little over a week. I have a few questions that hopefully you veterans of the North channel may know the answer to. We are very nervous as this is our first time out of the county and it all seems very intimating. 1)...
  11. andy k

    Loud clunking noise from alpha drive

    Today we decided to take our boat a few miles down the lake to a local island. When I started to trim up "ever so slightly" my port drive started to make a very loud clunking noise. I turned the engine off right away. I lowered the outdrive all the way down, straightened the steering wheel and...
  12. andy k

    Mercury ocean runner vs dynamic

    I am planning on replacing my baltik 8'6" dinghy with a 10'ish dinghy this season. My budget is $2,000. I am mostly interested in the Mercury line of dinghy's. I would like one that will handle rough water better and give me a drier ride than my solid 3 piece floor. Other than the obvious dual...
  13. andy k

    Radar issue

    As you can see from the picture, anything further out than about 1/2 mile becomes blured. I messed with some of the settings but cannot seem to get this to clear up. Thanks in advance for the help.
  14. andy k

    defender branded inflatable rib

    I am looking to get a new rib inflatable dinghy. I would like to know if anyone have used or seen the defender branded inflatable? I am looking at the 300 series. I am also looking at the Mercury rib, walker bay rib, and a zodiac rib. thanks
  15. andy k

    Battery wiring setup on 1997 40 Sundancer

    My Dad ha a 1997 40 Sundancer. We are struggling with the wiring for the battery's. We can't seem to remember how it was wired before we took the battery's out for winter. Any help would be appreciated. The boat is equipped with the gas 7.4l engines. Thanks
  16. andy k

    Sold my boat looking for a 290 da

    I sold my boat a few weeks ago and I am in the process of looking for a new boat. I am interested the 290 sundancer 1998-2001. I have a few questions about this boat. What can I expect for fuel consumption and performance for the various engine packages available? Is there a way to fit a fridge...
  17. andy k

    2006 Shorelander 8000 lb capacity

    I am selling my 2006 shorelander steel trailer. I used it to tow my 260 sundancer. -roller trailer -spare tire/carrier -black steel -disk brakes -surge brakes $4,495 OBO pm me if you have any questions
  18. andy k

    My first test of my $50 underwater lights!!!

    I bought 4 lights from one of the members here that makes underwater lights. I installed two on each swim platform. I am amazed at how well these work.
  19. andy k

    installing new head (where do I get the water?)

    I am throwing out the old portable toilet and installing a jabsco manual pump toilet. I would prefer to use the water out of the water tank rather than use lake water. My question is how/ where do I splice into the water tank? I assume that pressure from the pump would be a bad thing for the...
  20. andy k

    New line of sport boats from Cruisers Yachts

    I was playing around on the internet today, and noticed on the cruisers website that they are introducing a new line of sport boats. I know that cruisers used to make smaller boats and they stopped to focus on their larger boats. They only have one picture of a boat, but it looks really cool...
Back
Top