So it’s been awhile since the coolant has been changed in my engines and I was wondering if anyone knows the coolant capacities of these 6V92’s? Thanks in advance!
I'm changing all the fluids in the boat and I have a question on the trans fluid, specifically the v drive fluid. I have ZF transmissions with the v drives separate from the transmissions. They call for an SAE30 oil. My question is since the ZFs take an SAE 30, do the v drives take SAE 30...
Hi guys,
I'm having to remove my windlass to have some glass work done in that area (soft spot)/. I have loosened the 4 nuts that attach the gear housing thru the fiberglass and removed the motor to lessen the weight when/if it decides to come down. When looking at a parts diagram it seems...
I posted a few weeks ago about the genset problems I was having. Well, I have found a water pump through PartsforTechs.com but my problem now lies with getting a timing belt. I'm supposed to have a rounded tooth timing belt according to my serial#, but its a square tooth that I have and PFT's...
The 390's generator is running about 220 degrees and shutting off. I changed the impeller and pulled the cover on the heat exchanger. It had a little plugging on the bottom holes but nothing major. I got everything back together and its still running hot. Anyone know what type of motor...
One more question, I believe the lift pump on my port motor is also out, anyone know where to get one Its a walbro. I got my starter through the Kenworth dealer in Nashville but they said the motor mounted electric lift pump was a marine version and couldnt cross reference it.
ey, got a stupid question here, I was waxing the 500 yesterday and dropped the end of the extension cord in the water. I had the cord plugged into the aft exterior outlet(port cubby by the rear seat). Anyway, it kicked a GFCI or a breaker, neither of which I can locate. I reset the aft...
Hey ya'll just getting ready to get the season started and everything on the boat is ok except I'm not getting an Amp reading on the electrical panel. The Voltage is reading fine but the Amp side is blank. We just had a big flood here and the transformer for the dock went under so they cut the...
Well, I thought I had a genset problem and jumped downstairs to shut it off. I checked everything over and didnt have a problem (thought there wasnt enough water flow) so I started it back up. Now here's the problem, I didnt shut any of the panel switches off downstairs including all A/C...
My starboard wiper motor went out on me in a storm we had on the 4th. The motor is running but I think the tranny gears are gone. I pulled the cover and there is a lot of corrosion on the motor, wiring, and trans box so I think its time for a new one. Now, can I get one aftermarket or go to...
Hi All, I finally got the 500 back to her permanent slip and have been checking everything out. I am getting an "HHH" reading on the Salon A/C panel about the time it shuts down. There isnt any reference to it in the cruisair manual. Could this be a hot indicator for the water circulator...
I'm about to take delivery of my '93 500 Sundancer and I was wondering what you would suggest for filtration. It has Racor 900MA's (4 total) and a 500MA. She wont be here until early next week so I was going to pickup the filters ahead of time. I was thinking of 10 microns to 2 microns. Any...
Hello, I'm from Mt. Juliet, TN. I presently have an '89 390 EC (SAY WHAT) and just bought a '93 500 . We're taking delivery of her in a few days and I was wondering if anyone knows what fuel filters she takes (Detroit 6v92) and generator, I didn't get the part numbers when I looked at her but...