Hey guys,
I have a after-market bimini top on the boat from Westland. It is a taupe color to match the rest of the interior vinyl. Measurement from outside to outside is about 92".
I have am looking for one the says "Sea Ray" across the back like a factory bimini boot would say. I would...
Hey guys, just wanted your opinion on new-to-me boat. I just upgraded from a 1995 sea ray 175 (3.0L 4 cylinder) to a 2001 sea ray 190 signature (5.0L V8).
I have only been in this new boat once to test drive it. It is currently winterized already, so I will not have the chance to take it out...
Hey guys, Here is a simple question for some of you.
Last year my boat started just fine every time. Now this year, it normally starts right away and then dies. Then it will not fire a second time, unless I shoot it with starting fluid, then it starts right up. As soon as it is warmed up, then...
I recently purchased a westland bimini sharkskin top from Iboats.com.
The problem I have is that when I lay it down to travel down the road, it actually lays on the area the the engine cover is. Even in dry times, the dye from the boot rubs off onto the vilyn. It takes Go-gone to get rid of...
What is your local sea ray marina doing this weekend??
Well, I found out today that my first local aquapalooza for this coming weekend is pretty lame. Of course last year, they had a floating barge with a band playing on it. A huge get together and party that lasted pretty much all day...
guys....one quick question.
How hot is too hot to take the boat out? I have a vacation day to take at work, and I took tomorrow off work to take the boat out.
The only problem is that it is supposed to be 95 degress with 30 mph wouth winds. I dont mind the winds because I can stay close to...
Is there any way to adjust the throttle lever firmness?
I have the factory 3000 series, and when I am cruising in a no-wake zone....I have a hard time adjusting the throttle, like it is stiff or something.
I was thinking there might be a set screw of some type that would the lever to move...
I am looking into the possibilities of accepting a job at my local sea ray dealer. They have an position opening for a salesman. I have not yet applied there, but know a few of the salesman that currently work there.
What do you guys think of the idea of working for a boat dealer?? I do...
Man...I did a boneheaded move last night.
Was installing speakers in my boat and had a screw that was about 1/16 inch too long. Long story short....the tip went through the outside gel coat barely. Just enough to break through the side and crack the coating.
It is still above the waterline...
I just received my bimini top for my boat UPS today.
I am trying to figure out where to put the mounts for the main bow. The directions tell me to put the mounts on the flat surface on the top of the sides, tells me that have the forgiveness to the inside so the bow would go from outside in. I...
Hey guys, I would like to introduce myself.
Mike Lewis from Spencer Iowa, just 15 miles south of the great lakes of Okoboji. I have just recently purchased my first boat....a 18 Sea ray open bow.
Just curious if there is any other people from my neck of the woods!!
Later
Mike