Search results

Is the 1989 Bowrider 210 a "deep V" hull, or is it another hull design?

I have to replace my Mercruiser 888 (1977 302 188hp) in my '77 SRV 220. I have located a good used Mercruiser 888 (302, 188hp) that runs strong and is in good shape. My question is: It is out of a 1977 or 1979 Bayliner---will it fit in my SRV220? Shouldn't it just "bolt right in"? My first...

Due to freeze damage, I may end up completely replacing my Mercruiser 888---if I can afford it. What are my options for replacing this engine and/or outdrive? Currently has Mercruiser 888 with Pre-Alpha stern drive. What is biggest engine that will fit? Due to age, should I go ahead and...

I am still trying to source replacement heads for my '77 Mercruiser 888 (302) that had recent freeze damage. I have already heard that 351W heads are an option, but another local supplier tells me I should be putting GT40 heads on instead. Does anyone know if the GT40 (or GT40P) heads will work...

I thought that you could use automotive heads and that the only difference was to make sure to use a marine head gasket. In tracking down replacement heads, I was told the following by a vendor: "all the ford marine small blocks come with the guide and posi-lock style rockers. You would have...

Would these likely be 302 heads or 351 heads? I just assumed 302 heads, but someone told me they often used the 351 heads on these....how can I tell which I have?

Put on the muffs and fired up the boat for the first time this season but something does not look right--the boat was definitely taking water in thru the muffs, but water was coming out the drain (plug was out) and also being pumped out by the bilge pump. There was no water in the bilge before...

Anyone have a mid 70's to late 70's Mercruiser 888? I have a 1977 SRV 220 Cuddy with an 888 that needs a trim pump replaced. It has the "pre-alpha" 888 sterndrive. My trim pump assembly says 74436a2 on the label. Haven't been able to find this part anywhere, but found a 74436a9. I called...

My stern drive in my '77 SRV 220 is stuck in the full up position after being stored that way this winter. Tried standing on unit while trying to lower it--no luck. Shafts are not stuck/froze, I loosened the hydraulic lines a little (to allow pressure to release) and was able to push the unit...

I have a '77 SRV 220 Cuddy that needs a new cover for the anchor storage compartment (small storage area up at the bow, between the teak rails). The wood is rotted pretty bad. Where can I find a replacement cover, or the plans/specifications to make a new one. Where can I get the white outer...

Started boat for first time this season. Started up just fine but doesn't appear that any water is circulating thru cooling system. Had the muffs on but no water is discharged and water sprays out at muffs. Submerged outdrive in large tank of water, still no water discharged. Engine temp gauge...