Search results

i am looking to replace the rudder packing on my 2004 340da . but cant get an answer from searay. does anyone kinow what size it is.

I am looking to relace the packing on my 2004 340 da rudder assy. does anyone know what size it is?

help on how to perform rudder packing replacement on a 340 sundancer i am getting ready to for bottom paint and led lights on my 2004 340 da. while i am at it i want to replace the rudder packing. i think its 3/4 inch flux packing. any tips on how to go about it since this is my first time. i...

I have a lofrans progess 1 windlass and stripped out the retaining nut pn 508. the problem is that part is no longer available from the lofrans. I called every distributer and no luck. any ideas

I have a kolher 5 k genny that seems to run fine. however I think it may be running a bit hot. does anyone know what the maifold temp should read?

i have a 2004 sundancer with 496 engs. the port eng is unable to start and shows a code of 77 and 132....any ideas as to what to replace first

I have a 2004 340 sundancer with a kolher 5k genny. I believe the impeller shaft is sheared on the genny. the shaft does not spin while the genny is running however it can spin freely by hand. can anyone tell me if there is a shear pin installed and where to find it thanks all

I am changing the color of my 2004 340da canvas and will be selling my tan colored bimini canvas. comes with side enclosures as well as visor and rear curtain with window. no tears and still in good shape. have not yet thought of a price. pm me if anyone is interested.

I am looking to replace my carpeting in the cabin, I just want to order it online and have it delivered to my house. any good sites to order from?

which transmission (port or starboard) turns the opposite direction from the direction the engine is turning on a 2004 340da with 8.1L v drives. is it normal for that transmission ( which turns opposite direction from eng)to make a slightly louder noise while in gear compared to the other drive...

at idle while putting my port v drive in fwd or rev i can hear a slight humm or buzz. the starboard remains quite. any ideas?

can someone send me the wire diagram for a 2004 8.1 L sea water pump pressure sensor. or post the info for the 3 wires going to the sensor.

i have an issue with my starboard 8.1 l eng. its goes into guardian mode as a result of the sea pump pressure at 3psi at idle while my port eng shows 43 psi at idle. I changed the impeller and still no change. I replaced the sensor and again no change. (just in case your wondering I am using my...

I am looking to replace my smart view display as I cannot see anything on it anymore contact me at larrydyncorp@yahoo.com

I have a 2004 340 and the smartcaft display is almost unreadable. where to get it replaced or repaired. any generic brands that can be used?

i am looking to purchase one, is that a yr which I should avoid or is it a reasonable used boat to buy