Hi.... My friends 410 has for 3 years had intermittent exhaust water flow issues...impellers were changed with no difference....water flows for a short period of time (a few seconds) then stops then water shoots out and repeats. there are no temperature problems. Any ideas what might be causing...
Here's an interesting device, apparently locks prop on to shafts and removes them with no damage and can be used underwater. And made in NC........anyone use them?....comments...
propsmith.com
The 1997 vintage Raypilot started doing some crazy things on flatwater We made a small course correction to starb. using dial and boat immediately turned hard right then corrected with a hard left and slowly settled into an apparent straight course as seen on chart, but autopilot kept making...
Hi....main salon HVAC (Cruiseair)will not control temperature when in heat mode, it will start unit when temp. drops below setpoint but will not shut down unit when temp is reached and keeps heating until I manually shut off unit...Is there any trouble shooting that can be done? or does wall...
Hi.... anyone boat in Tawas Mi. area just looking for general info and a good marina for 4 nights. Any fireworks in area July 4th?...thanks, for any info..... Tm
Would appreciate owners opinions on bravo 3 reliability good or bad, assuming of course regular maintenance has been performed and unit has always lived in freshwater... a friend is interested in buying a 2000 340DA with Blll's and 400 hrs. Of course if the time comes surveys will be done...
Hi.... just started removing factory original raytheon radar 41xx. Before frustrating myself wondered if anyone knows whether Sea Ray always tywraps cables together making removal of cable(from arch to CRT) in one piece virtually impossible. Unit is sold and would prefer not to cut the 16 pin...
Went for a run today before haul out and tryed full throttle run...boat was lightly loaded (1/8 fuel + 1/4 water) and had a slimey bottom yet engines wound up to 3050(Aetna digital tachs) and was still climbing higher when I backed off, not expecting to see that hi RPM. Expected to see just a...
just finished oil change and need some input, please... noticed oil level on both engines are 1 inch above full mark, after putting in 25L of oil as specified by maual...and filters were filled(aprox.2L) prior to installation but engines not started yet.... am fairly sure all oil was pumped out...
with excellent advice and tips from CSR members changed out impellers(to get baseline since last impeller change was a guess from former owner) on new to me always freshwater SR400DA all went well....BUT stb. engine had 75% less flow(strainers appear to be clean) before change out and appeared...
Tryed a search but did not see same problem.... has anyone had engine oil in air filters(stock Cat filters), enough so there is minor leak coming out of filters...turbo problems? prognosis? and how to solve issue if serious, please....thanks in advance for any help or advice...... Tom
Hi...need ideas, please...
had some plugage in aft head and cleared that also snaked line to vac.pump and seemed to be cleared. Pump would not run, checked voltage at pump(OK) and jumpered vac.switch and pump seemed to run and sound normal. Could discharge line to holding tank be plugged? or is...
Anyone have dificulty with their fridge, mine wont cool but power supply was checked good and authorized dealers either dont want to or can't repair the cooling unit and are recommending replacing whole fridge. Of course that model does not exist anymore but DE0061 seems to have same...
After a 6 hr run there appears to be some red tranny fluid beneath the port v drive maybe a cup and cant find any obvious gasket leak, dipstick was on tight as fluid was checked before trip.....any ideas suggestions, much appreciated... Tom
Hi.... am in process of purchasing boat in USA from CANADA.... asked broker if they guarantee clear title and broker said that is owners responsibility who freely admitted loan on boat... does broker really have no responsibility obtaining clear title? path forward? thanks for helping.