Search results

2006,340 DA, bravo iii, 8.1 engines with system view and Raymarine chartplotter Does anyone know where the sea water temperature sensor is located that is part of the system view? With chartplotter on, the sea temp reads out on the system view. With the chartplotter off I get a very...

496, Bravo 3 outdrives. Had the lower unit gears replaced this spring. Boat used appox. 6 hours since the work was performed. After a short 1 hour ride, and then a break for dinner, the port engine would not start. The starter was making a high pitched whirring sound. Pulled the starter and...

Lower units taken off last fall and put on this week. Prior to removal was able to trim both lower units up and down but kept receiving and error message on Smartcraft: Port Fault 131, Trim Ckt Lo. Boat has not been in water yet but we are told that neither lower unit responds to the...

when plugged into shore power, do the solenoids need to be left in the on position to charge the batterys or would having the ac converter switch "on" accomplish the same result? can the solenoids be damaged by being left on continually? When we purchased the boat, the dealer said to just...

Does anyone know what the alarm message "Port fault 131, trim ckt lo" means? Our manual doesn't offer much help to locate the source. All fluid levels are full. The error seems to come up more when cruising, than when at idle speed. Clearing the alarms doesn't get rid of the problem. It...

2006 340 DA, gas, 8.1's with smartcraft. My fuel guages are reversed; left is actually the right and vice versa. The guages on the dash and the smart craft both give the level for the wrong tanks. Anyone know how to fix this?

I have a new '06 340 DA. I have been having an alarm problem related to the gray water bilge. I always seem to get seepage back into the sump box from somewhere that triggers the sump and then the alarm. The shower and sink have never been used. We have used the AC several times but not...