Recent content by shpclay

sea ray says it has a 14x19 3 blade is standard. The 14 is a little hard to find. Anyone know of a place?

Hey guys I need to replace both props on my 1988 300 with twin 350 alpha 1's I'm trying to figure out the best size to get and if I should go 3 blade or 4 blade... Any help would be great!

Thanks, I found the blum which is what is on the boat. I can order but I will try Lowes first. thanks steve

1988 300. hinges are recessed into the wood. Anyone know where to get these. One part slides into another.

done

Have a 300 sea ray and im planning on taking my weimweiner and two weiner dogs. Neither aare crazy about water. Some people Iv'e heard tow a small boat and carry them to shore.

Anyone know how to carry pets on a boat for a few days. steve

Thanks, found access yesterday. Enough room for one hand. I'd say your right about the gauge failure. Sure would like to go one week without a problem, I guess this won't happen. steve

My port worked fine and one day it wouldn't register at all. Just need to fine out where the sending unit is located.

Gauge doesn't register, I don't thinl it is the gauge. I noticed on another post that you can get to the sending unit through the side storage locker on the port side. Does anyone know? steve

Thanks, that sounds about right. Its about like going uo to volunteer marine and back to concord. It took me a little less than a half of a tank to do that 66.7 miles round trip. Looks like it would take most of a full tank on my 30 ft which is 140 gal.

Anyone know the mileage from concord to euchee. steve

A zip lock bag works pretty good also.

I have a 88 sundancer 300, heater I guess is orignal. What will fit in the hole all the new ones are square, the old is round and lays on its side. It is 13 inches from bottom of compartment to bottom edge at the opening.

flounder pounder was intersting, lot of stuff for sea ray. thanks