I was lucky one of the screws is behind the interior light. The other one. Had to go thru the top and I used a button snap over the screw to blend it in better.
looking for a tri axil boat trailer for my 2004 Sea Ray 280 Sundancer. needs o be able to haul 10k. I would like to have brakes on all 3 axils. Need one that is build for this boat so that I can keep my height down.
Thanks
2004 Sea Ray 280 Sundancer, Very clean and well maintained 280 Sundancer with berths for six, full-service galley, and V-berth that converts into a second dinette. Built on a deep-V hull with a moderate beam and an integrated swim platform. The single-level cockpit is arranged with a sun pad...
I have1 tab that keep sliding out of the grove. It moves about 1 inch of center. I can move it back with a rubber mallet but I afraid it's going to break the acuator mount. Can this be repaired or do I need to replace it?
I will take some photos tomorrow. Yes there colors matched. But all you have to do is match them against the pumps connect plus which they are currently connected to. I still have to take it out and calibrate it and then I will give you my thoughts. While I was at it I also installed the...
I had to run 8 wires from the helm to the trim pump in engine room. To do this i had to remove the throttle cover to get access for running the cables. You use 4 wires from the relay by the pump and connect those to the atc. The from the atc you would use the other 4 wires and push the...
Called tech support and they help me fix the problem. Issue was with the wiring at the atc. I needed to swap my green and yellow wires. There tech support was very helpful .
I am at my wits end. I installed the relay, atc, and control unit. The system was working correctly before Install. When I put system back to original setup it still works correctly. I ran 8 wires from the relay box to the helm. When I put a loop on the 8 wire at the helm I can use it...
I am having trouble running the the new remote cable to Iinstall the mw1 controller. Anyone eever done this and have any advice on how to run this cable?