2004 280 Sundancer $42,900

davidald

New Member
Jun 14, 2014
15
Sarasota, FL
Boat Info
2004 280 Sundancer
Engines
2- 4.3
2004 Sea Ray 280 Sundancer, Very clean and well maintained 280 Sundancer with berths for six, full-service galley, and V-berth that converts into a second dinette. Built on a deep-V hull with a moderate beam and an integrated swim platform. The single-level cockpit is arranged with a sun pad opposite the helm, an aft-facing bench seat, wet bar, and a retractable rear bench seat that folds up into the transom when its necessary to get into the engine compartment. A large storage locker is built into the transom, and molded steps at the helm provide easy access to the walk-through windshield. Both sterndrives rebuilt in November 2014. Compression check was done in June 2014, new fire suppression system July 2014, New rode, new canvas cover and many other upgrades and maintenance recently completed. Port engine has 517 Hrs. Starboard engine has just 297 Hrs. Over 8k put into her in the last year. Runs like a dream. Always stored at a marina or on Lift. Cost Guard Documented. Absolutely Beautiful Boat! $42,900.




Starboard engine


6/15/14 Replaced IAC
07/12/14 Replaced fuel/water separator, top off trim steering fluid, and cleaned flame arrestor

0/14 replaced all zincs
08/02/14 changed oil and flirter 475/hrs
09/16/14 Over hauled Stern drive
New gimbal bearing, shift cable. Outdrive gasket, gimbal bellows, gimbal boot, sleeve oil line hose, water line hose, oil tube, lower unit lube ,water pump impeller, sender kit, exhaust boot. shift cable, starboard side 2x trim lines, prop kit, resurfaced prop, shift lever assembly.

Port engine
07/17/14 changed fuel/water separator
08/14/14 installed zincs
09/14 changed oil and filter
09/16/14
Overhauled sterndrive
Gimbal bearings, shift cable, cross bearings (U-bolts), outdrive gasket, gimbal bellows, gimbal boot sleeve, oil and water hose, oil tube, lower unit lube, water pump impeller. Sender kit. Exhaust boot, shift cable not, prop kit, resurfaced prop, shift lever assembly.

5k generator
07/14/14 Changed oil and filter 261
09/5/14 cleaned heat exchange (soaked in barnacle buster) topped of anti-freeze.
04/15/15 changed both spark plugs

06/15/14
Cleaned and flushed AC filers.
Head
08/14/14 put chemicals in the tank
08/14/14 installed new seat cover.

Anchor
07/14 new rode 200’ with 14’ chain

07/14 new engine room fire suppression system
3 New cabin extinguishers
08/20/14
Installed New VHF radio and antenna

08/17/14 installed new clarion radio controller at helm
08/25/14 installed new spotlight with helm control
09/2/14 installed new cup holder on port side.
11/15/14 installed new canvas cover for storage.
 

Attachments

  • 20141120_085349-crop.jpg
    20141120_085349-crop.jpg
    77.9 KB · Views: 1,029
  • 20150824_172608.jpg
    20150824_172608.jpg
    57.5 KB · Views: 1,016
  • 20150824_172613.jpg
    20150824_172613.jpg
    63 KB · Views: 1,022
  • 20150824_172741.jpg
    20150824_172741.jpg
    60.9 KB · Views: 1,015
  • 20150824_173158.jpg
    20150824_173158.jpg
    55.8 KB · Views: 1,013
  • 20150824_173411.jpg
    20150824_173411.jpg
    67 KB · Views: 1,033
  • 20150824_173433.jpg
    20150824_173433.jpg
    72 KB · Views: 1,018
  • 20150824_173546.jpg
    20150824_173546.jpg
    70 KB · Views: 1,028
  • 20150824_173554.jpg
    20150824_173554.jpg
    64.4 KB · Views: 1,019
  • 20150824_173637.jpg
    20150824_173637.jpg
    58.4 KB · Views: 1,014
  • 20150824_173643.jpg
    20150824_173643.jpg
    57.6 KB · Views: 1,033
  • 20150824_173657.jpg
    20150824_173657.jpg
    47.1 KB · Views: 1,020
  • 20150824_173734.jpg
    20150824_173734.jpg
    90.5 KB · Views: 1,027
  • 20150824_173817.jpg
    20150824_173817.jpg
    92.2 KB · Views: 1,018
  • 20150824_173836.jpg
    20150824_173836.jpg
    92.9 KB · Views: 1,015
  • 20150826_133239.jpg
    20150826_133239.jpg
    51.6 KB · Views: 1,017
  • 20150826_133248.jpg
    20150826_133248.jpg
    52.6 KB · Views: 1,024
  • 20150826_133257.jpg
    20150826_133257.jpg
    91.8 KB · Views: 1,020
  • 20150826_133339.jpg
    20150826_133339.jpg
    53.1 KB · Views: 1,020
  • 20150826_133353.jpg
    20150826_133353.jpg
    54 KB · Views: 1,014
  • 20150826_133412.jpg
    20150826_133412.jpg
    54.6 KB · Views: 1,008
  • 20150826_133423.jpg
    20150826_133423.jpg
    59.4 KB · Views: 1,019
  • 20150826_133508.jpg
    20150826_133508.jpg
    53.9 KB · Views: 1,018
  • 20150826_133542.jpg
    20150826_133542.jpg
    45.7 KB · Views: 1,008
  • 20150826_133604.jpg
    20150826_133604.jpg
    62.3 KB · Views: 1,018
  • 20150826_133615.jpg
    20150826_133615.jpg
    55.4 KB · Views: 1,013
  • 20150826_133725.jpg
    20150826_133725.jpg
    68.3 KB · Views: 1,004
  • 20150826_133740.jpg
    20150826_133740.jpg
    63 KB · Views: 1,002
  • 20150826_133806.jpg
    20150826_133806.jpg
    72.3 KB · Views: 1,008
  • 20150826_133840.jpg
    20150826_133840.jpg
    54.3 KB · Views: 1,000
  • 20150826_133845.jpg
    20150826_133845.jpg
    64.6 KB · Views: 1,011
  • 20150826_133856.jpg
    20150826_133856.jpg
    44.4 KB · Views: 1,003
  • 20150826_133915.jpg
    20150826_133915.jpg
    57.6 KB · Views: 1,001
  • 20150826_133952.jpg
    20150826_133952.jpg
    84.5 KB · Views: 1,052
  • 20150826_134011.jpg
    20150826_134011.jpg
    59 KB · Views: 1,013
  • 20150826_134118.jpg
    20150826_134118.jpg
    55.2 KB · Views: 1,003
  • 20150826_134135.jpg
    20150826_134135.jpg
    54.8 KB · Views: 1,005
  • 20150826_134149.jpg
    20150826_134149.jpg
    61.4 KB · Views: 999
  • 20150826_134158.jpg
    20150826_134158.jpg
    65.6 KB · Views: 991
Nice boat. Was the cup holder hard to install? How did you get access? I'm looking to install same one on my 04
 
Nice boat. Was the cup holder hard to install? How did you get access? I'm looking to install same one on my 04
I was lucky one of the screws is behind the interior light. The other one. Had to go thru the top and I used a button snap over the screw to blend it in better.
 

Forum statistics

Threads
113,163
Messages
1,427,599
Members
61,072
Latest member
BoatUtah12
Back
Top