CLH
Member
Greetings. I'm trying to install a hailer horn on the hard top of my 460 DA and I started the wire from the underside of the hard top where I removed the round access port (where the VHF is mounted to the hard top). Then I fished this new speaker wire down the STBD side of the arch where I removed the large panel, and I've hit a road block. I am trying to get the wire from there to the helm by going forward. I see some "chases" that are a black corrugated "hose" and have wires already in them. But so far I've not been able to get the speaker wire to come out anywhere forward of the arch and I can't see where it might come out. Tips?
Also, I need to fish a new coaxial cable from the forward stateroom TV, along the PORT side of the hull (behind the head, behind the galley), to about midships where it will attach to the splitter for the Glomex antenna. Tips? For this one, it's not a simple matter of attaching to the existing coax and pulling it on through, due to all the wire tie connections holding the old coax in place.
Thinking about buying one of those wire fishing rods...
Cheryl
Also, I need to fish a new coaxial cable from the forward stateroom TV, along the PORT side of the hull (behind the head, behind the galley), to about midships where it will attach to the splitter for the Glomex antenna. Tips? For this one, it's not a simple matter of attaching to the existing coax and pulling it on through, due to all the wire tie connections holding the old coax in place.
Thinking about buying one of those wire fishing rods...
Cheryl