obsessive
New Member
My 99' 240DA had a new coat of bottom paint put on it last spring. Well, after pulling her out at the end of the season, I noticed that a few areas were flaking off (not big areas), and that they need to be touched up.
Whats the best process for this. All the other areas on the hull look great, only these 4 spots need touch-up (fist sized).
I was thinking agout sanding with a foam 80 or 100 grit sanding block around and over the areas in question, wiping them clean with a damp cloth (to get rid of the dust, etc.), letting them fully dry, and then overpainting with Interlux.
Is this a good approach?
Eric
Whats the best process for this. All the other areas on the hull look great, only these 4 spots need touch-up (fist sized).
I was thinking agout sanding with a foam 80 or 100 grit sanding block around and over the areas in question, wiping them clean with a damp cloth (to get rid of the dust, etc.), letting them fully dry, and then overpainting with Interlux.
Is this a good approach?
Eric