maxse
Member
- Apr 16, 2017
- 108
- Boat Info
- 260 Sundancer 2007
- Engines
- Single Mercury Stern Drive 300HP Bravo III
This is from SmartCraft directly:
System Fault...
Engine Sensor...
Trim position sensor is not working properly...
It happens typically within 5 minutes or less of starting the engine. The trim gauge in smartcraft (digital) changes when trimming up 0 - 1 etc. also the analog gauge works.
The dealer tells me there may not be a sensor this is why I am getting the error. Any suggestions?
System Fault...
Engine Sensor...
Trim position sensor is not working properly...
It happens typically within 5 minutes or less of starting the engine. The trim gauge in smartcraft (digital) changes when trimming up 0 - 1 etc. also the analog gauge works.
The dealer tells me there may not be a sensor this is why I am getting the error. Any suggestions?