Dustin Brewer
Member
Hello all! I have a raw water cooled 1999 Sundancer 270DA with a single 7.4mpi. The lower water inlet hose leading to the impeller pump is leaking just before the nipple on the pump housing. I am going to try and cut the bad section off and reattach it. There is not alot of extra hose, and its quite stiff. I have 2 questions. The first being whats best to cut the hose with? I was thinking a hack saw? I am replacing the starboard manifold this weekend, was thinking it would be easier to access the hose with that out of the way..
Second question, if this doesn't work and I need to replace it, where does it connect to on the other side? I can follow it until it goes under some of the steering components aft of the engine and I loose it. Does it go into the upper part of the drive? Any help you can lend me would be amazing!
Second question, if this doesn't work and I need to replace it, where does it connect to on the other side? I can follow it until it goes under some of the steering components aft of the engine and I loose it. Does it go into the upper part of the drive? Any help you can lend me would be amazing!