Irie308
Well-Known Member
- May 28, 2013
- 2,602
- Boat Info
- 2004 420 DB, GHS Hydraulic Lift
Garmin 8600/Garmin 1222 plus
AB Mares 10 VSX with 30 hp Tohatsu
- Engines
- Cummins 450C 8.3 L Turbocharged
What is the best way to go about repairing holes in the the radar arch? I'm in the processing of adding a dual mount which replaces a single radar mount. The picture attached shows what's left after I removed the old mount. I'm not too concerned about the four holes in the middle as they will be covered by the new mount but I want to make sure they are water tight. Now the holes that housed the anchor light and the radar cable will be exposed. What's the best method/product to fill and seal them up? I'm not to concerned about looks as they are on top of arch.