jaywoodz
Member
- Nov 12, 2012
- 522
- Boat Info
- 1999 Sea Ray 310 Sundancer
- Engines
- Twin 350 MAG MPI Horizon w/V-Drives
I have a NMEA 2000 network tied in with my Raymarine e120 classic. I have a Mercruiser N2K gateway that takes smartcraft and turns it into NMEA 2000. I have a smartcraft sensor tied into my engine(s) that reads both my port and starboard tank %'s. As in percent full. I've attached a picture. Problem is.. even in the slip, not in gear, low wind and very little rocking on the boat, my tank percentages jump around SO much. For instance, I watched them for about a minute. Each tank jumped anywhere from 17% to 40% full. Just sitting there! It's terrible, and almost worse than analog that control the spiking. Is there anything I can do to get these to stop jumping around so much? It's terrible and I can't get an accurate reading for my tanks.