Harmon
Member
- Jun 28, 2011
- 363
- Boat Info
- Current: 2006 320DA as of 6/7/19
Previous 1997 Sundancer 250
1989 Basstracker 40HP
- Engines
- Twin 350 Horizon with Vdrives
Single 7.4 Ltr carbed
Bravo 3 outdrive
Thank you very much. I was at boat yesterday and there is an access port, just a crappy cover plate with four screws and two crack. I'll be installing a spin open with a seal. Seems like this was a water incursion spot. Hosing the deck and water would go in under that storage and run over that plate, thoat surely leaked.Don't need to seal the edges. Just put sealant around the cover plate. Disconnect battery with hatch open. Sender has a gasket no sealant needed. I used a power screwdriver with a nut driver and alternately tighten nuts. My tank was full also. Use a shop vac as you drill if you need the access hole. Wipe the top of the tank off before you remove the old sender. Probably getting the screws started by hand is the hardest part. Takes a little feel and patience.
There is another drain area under back seat too. If you hosing out storage there's now direct path for water/debris. It pools there and also in trunk as well. Did u do anything to increase drainage?