- Jan 26, 2008
- 2,839
- Boat Info
- SOLD 2005 420 DA w/T-8.1S Horizons
- Engines
- 2018 Sea Hunt 255se w/Yamaha 300hp
Hello All,
I have a '93 Searay 400 EC Express Cruiser. It has a large plexiglass companionway sliding door. This door open is connected to an upper and lower rail by four nylon 'trucks'. These are solid pieces of plastic/nylon that are about 1 to 1 1/2" long. The cross section is like a very fat 'T'. The top of the T slots into the tracks while the door is secured to each truck using a single machined bolt that passes through the center of the truck. There's a nut countersunk into the truck that the bolt screws into.
Here's my problem. One of these has snapped in half (I only have the one half) and I'm finding it IMPOSSIBLE to find a replacement part. I've now worked with the local MarineMax for 2.5 months and received 2 parts that have both been wrong. In fact, neither one was even close.
They're suggesting that I replace the rails and trucks but the rails are an integral part of the door frame and it would be a LARGE Task. All for a $20 part.
Any ideas on how to source these or how to have one made.
Any help or guidance would be greatly appreciated.
TIA.
I have a '93 Searay 400 EC Express Cruiser. It has a large plexiglass companionway sliding door. This door open is connected to an upper and lower rail by four nylon 'trucks'. These are solid pieces of plastic/nylon that are about 1 to 1 1/2" long. The cross section is like a very fat 'T'. The top of the T slots into the tracks while the door is secured to each truck using a single machined bolt that passes through the center of the truck. There's a nut countersunk into the truck that the bolt screws into.
Here's my problem. One of these has snapped in half (I only have the one half) and I'm finding it IMPOSSIBLE to find a replacement part. I've now worked with the local MarineMax for 2.5 months and received 2 parts that have both been wrong. In fact, neither one was even close.
They're suggesting that I replace the rails and trucks but the rails are an integral part of the door frame and it would be a LARGE Task. All for a $20 part.
Any ideas on how to source these or how to have one made.
Any help or guidance would be greatly appreciated.
TIA.