Guys, When I turn the ignition key there is no beep or clicking...Outdrive WILL raise and lower normally and engine will not crank. Throttle perfectly neutral. This is what has been tried so far...
1-no power to fuse panel after a test
2-5 fuses in engine area all test fine with meter
3-ran jumper from +battery to + on basic blue seas fuse panel—-when stacked on existing -starts fine—A-ok
4- running only jumper from battery+ to fuse block+ ( factory fuse panel + disconnected) starter solenoid clicks.. no start...
5 -tried new Sierra 18-5816 solenoid—-same result
6-tried jumper across 50 amp engine fuse ...( continuity good) same result-nada
7- checked cut off/kill lanyard switch and bypassed... nothing
8- hooked up new Sierra ignition switch.... no change.. nada
9... thinking gotta be a 6th hidden fuse ... not shown of factory wiring dwg... but dwg shows a battery switch so cost cutting
10-re-connected jumper from battery+ to fuse block + ( stacking on existing wiring)... all works....
11– maybe a ground issue——jumpered neg-battery to neg fuse panel ... no change
Any help appreciated!
1-no power to fuse panel after a test
2-5 fuses in engine area all test fine with meter
3-ran jumper from +battery to + on basic blue seas fuse panel—-when stacked on existing -starts fine—A-ok
4- running only jumper from battery+ to fuse block+ ( factory fuse panel + disconnected) starter solenoid clicks.. no start...
5 -tried new Sierra 18-5816 solenoid—-same result
6-tried jumper across 50 amp engine fuse ...( continuity good) same result-nada
7- checked cut off/kill lanyard switch and bypassed... nothing
8- hooked up new Sierra ignition switch.... no change.. nada
9... thinking gotta be a 6th hidden fuse ... not shown of factory wiring dwg... but dwg shows a battery switch so cost cutting
10-re-connected jumper from battery+ to fuse block + ( stacking on existing wiring)... all works....
11– maybe a ground issue——jumpered neg-battery to neg fuse panel ... no change
Any help appreciated!