vesselview

Good evening all, Just got vesselview mobile for my 2001 Sundancer 340. I connected at the engine because I have no smartcraft jboxes at the helm (I think that started on 2003). Can I simply connect my other engine (8.1L Horizons) with a new cable or do I need junction boxes? I've searched...

I am looking to add a junction box to my helm in order to simultaneously run my helm smartcraft guages as well as Mercury VesselView Mobile. Currently, my 10-pin engine harness runs directly from my engine into my Tachometer (the tach has a small digital display for smartcraft data). Can I...

All, I received this error/alarm this weekend. The engine went into automatic protection mode at this point. The engine runs smoothly and sounds fine to me, but I'm not a trained mechanic. Is this an ignition coil issue? If so, wouldn't the engine sound rough?

I have a 2003 380DA. Gas 8.71 engines (2). My Vessel View is no longer lighting up at night... has anyone replaced their Vessel View with either a direct replacement or upgraded version? Thanks, Mike

I wanted to share what I have done and more than happy to answer any questions. I have upgraded to a new electronics and panel on my cruiser. I call this project phase 1. Phase 2 will include a Fusion unit and Fanthom Radar. I'm looking for a solution for the white lettering on the black...

I am a new owner. I apologize in advance if this is a silly question. I just bought a 2020 210 SPX, the spec sheet says that it comes with Vesselview. Do I also need to buy the module? That is not clear on the spec sheet. I was unable to connect to the engine from my phone. Thanks.

I have installed the new VesselView 4 inplace of the Smartcraft sc5000. All items appear to work on the new unit, but the Smartcraft analog gauge does not work for the fuel only. All other parts of the analog gauge are working. I can see fuel level on the VesselView. The fuel level was working...

Hello Crew, I just purchased a 2014 Sea Ray Sundancer and will have it next week (can't wait :D). My current boat is a Chaparral 290 Signature with Garmin Chartplotter and Auto Pilot and I am enjoying all the features like Auto Guidance and automatic Auto Pilot engaging from my Garmin setup...

Hello All: I have a 4 port Smartcraft junction box (shown below) at the helm going to my present guages. I want to install the Vesselview Mobile device and do not have any ports available on the 4 port unit. Can I just purchase a Smartcraft 6 port junction box and swap it out, or is there a...

This should be in my signature but I will repost it anyway. I have a Sundancer 340 2003.5. 8.1 Mercruiser's Inboard. It has a vesselview system that has been installed at some point since so it is not the original. It's also not the new version 4 or 7. Basically the problem is that there was a...

I am trying to covert over to VesselView on a 2003 380DA. Mercury confirmed compatibility over the phone according to the engine serial numbers. I purchased a used vesselview and appropriate harnesses. The problem i encountered is that behind the lower instrument panel i only see one 4-port...

Have a Smartcraft Vessel View Part # 8M0034881 new in the box. Only has display with no cables. Will take 200.00. Can send pics upon request. Thanks