hose

I know I can get it from the dealer, but I am just looking for about a foot for the transom to the stern drive. I am not ready to change the hose on the engine side. Does anyone know where to buy it by the foot? I read about fuel lines and hydraulic hose and am confused what to buy. I know...

Hi, I am in the process of replacing all of my raw water intake hoses with Shieldsflex II hoses. The present hoses are 16 years old so in most cases I am cutting them off due to the stiffness. I have two questions that I would like some input on: 1) What is the best way to clean the metal...

Now that my fuel lines are all 19 years old I think its time to change them. Im going to buy the fuel line in bulk length and have a local line/fitting shop install all the threaded ends. Considering there are so many connection points I will to do one side at a time so I don't confuse how they...

I have a 2005 Sea Ray 270 Amberjack with 496 Mercruiser Mag engine. I recently replaced the raw water pump. Now I have a small hose coming off the top of the pump (above the air fittings) that is not connected to anything. I don't remember disconnecting it and don't see any place for it to...

Yesterday I took apart the overflow tanks and hoses out of the boat - they had back mold on the inside. I soaked in bleach and water for a few hours. The tanks came out good but the hoses still have all sorts of stuff inside them and I am having trouble cleaning them - easier to replace. What...

I'm looking for this in the parts guide. I have a picture myself, but also have a stock one from the parts manual. It seems that the galley sink was leaking very badly causing water to collect in the bilge and cause heavy condensation with mold/mildew. After finding the source, I noticed the...

Not sure how, perhaps one of the kids pulled too hard on the spray head, but my transom sprayers started leaking water from the hose. I decided to replace the hose and ducked down under the engine cover with my trusty wrench. First mistake. I discovered that the metal cover on the line is...