Currently don’t have pictures but the leak is coming thru the gasket that holds the window in the frame. I would guess the rubber gadget gets hard from exposure and the no longer can keep out the water. I am going to visit a window company to see if they can replace the rubber gasket.
we have a 1996 330 Sundancer. During a recent heavy rain I noticed water leaking thru and around the window glass and the rubber channel. Is there an ‘easy’ way to seal the glass in the channel? Or, does the channel all need to be replaced? Has anyone done the replacement? If so difficult and...
I have a 1996 330 Sundancer that I am trying to install a gas fumes sniffer. Is there any tricks or hidden passages that can be used. It looks like all the wires and cables from the dash area lay on top of the starboard fuel tank. Any guidance would be appreciated.
Transom locker it is. My error on calling it a trunk. I am going to get behind the water inlet and see if that is leaking. Already check the transom shower and that was good. Thanks for all the info and correction on description 'trunk'. Thanks..
We are new to the Sundancer with a 1996 330. Seems like a great boat. With all the rain in the Great Lakes area the inside of the trunk is always wet. Is this normal? Would like this area to be dry. Water also seems to seep from the trunk to the back of the compartment where the hose connection...
Has anyone replaced the rollers on the cabin entry doors? If so where did you get the replacement rollers and how did you get the sliding door out? I have adjusted the rollers many rime but I am close to not have anymore adjustments. Tx
Excellent,,post #128 was just what I was looking for. Now if I can only make myself like a pretzel the job will be easy. Getting to the rudder post is 90% of the work. Thanks
I have a 1987 340 EC and the port Rudder Post is leaking. I am guessing that the rudder needs to be re-packed or tightened.
Has anyone done this on this vintage? What is the prodedure for repacking the rudder post? Any gottcha's?
Thanks
Bill
I have an 87 340 EC and replaced all the interior cockpit panels. I used marine plywood and had them recovered with fabric to match the seats. I called the factory and they sent instructions on how to remove the panels, As was stated above it is a process but not difficult. The old panel do make...
Does anyone have a source for old Sea Ray parts?? I have a 1987 340 Express and I am in need of a replacement dash switch panel. The panel is a blue graph design with all the cutouts for the switches and lableled. Of course the panel is pressed something (cardboard) and is cracked. Is there a...
I have a 1987 340 Ex with twin Crusader 454's and it seems like both are producing a lot of exhaust steam. I have changed both impellars and there seems to be good water flow from both exhaust. This is in fresh water and the boat has never been in salt water. Approx 625 hours on the engines. Is...
Kevin..I did this task this weekend...The window are faily easy to replace, but frustrating and time consuming.. When I put the new trim rings on they did not snap into place like they should have. I was very disappointed in the fit of the ring to the window..All 4 had the same issue..Therefore...
The 80's Sea Rays have 4 portlights on the bow that are thin plastic non-opening windows. All 4 of mine have cracks. I have the parts to replace them. Has anyone done this? any tips or do's and don'ts? Thanks