Search results

  1. D

    Why melting your exhaust flappers is not good.

    A few weeks ago, I managed to overheat my boat and in the process, I managed to melt the exhaust flappers / water shutters. All that was left of the flappers were the small pins that the flappers hinge off of. After asking around, I was given a lot of advice ranging from "the pieces will...
  2. D

    water shutter / flapper access

    Hello All- I have a 195 Sport with a 5.0 TKS. I am trying to gain access to the water shutters / flappers, however I cannot get the elbow seperated from the rubber tubes. I can get everyhing really loose, however there is not enough clearance to completely pull them apart. I suppose I could...
  3. D

    pic test

    Test
  4. D

    Oil Filter on a 5.0 motor

    I need to change the oil and oil filter on my 5.0 motor. The oil filter is located at the bottom of the motor and is a nightmare to access. On top of that, it was put on by He-Man and will not budge. Before I apply a lot of pressure on it, which way should i be turning it? I want to make...
  5. D

    Anyone replace the stock rear speakers on your 185 or 195 Sport?

    I am looking at replacing the stock rear speakers on my 195 Sport and noticed that the stock Panasonic speaker cut out is 5.5 inches in diameter. The speakers I am looking to install require a 5 1/8 cut out so I was wondering if the stock cut out will be too big for the aftermarket speakers...
  6. D

    195 Sport Propeller Recommendations

    Hello All- I just picked up a new 2007 195 Sport with a 220 hp TKS motor in it. The boat has a standard aluminum prop on it, however I failed to get the size off of it. While out on the Potomac river today, I noticed that with 4 adults on board and a 3/4 tank of gas, the boat would hit about...
Back
Top