Search results

I just picked up an older (but new in the box) inverter. It's 1000 Watts with a 2000 Watt surge. I am trying to find the best way to wire it into the boat. I am considering getting a switch and wiring the 110v from the inverter and shore into the switch. I was thinking I could place the...

John and company, I have posted a few times about the starboard side of the engine running hotter than the port. I have played around with the hoses and hot water heater hoses to no avail. I finally picked up an IR gun from Sears. Here is what I found. At hot idle after a run: Starboard...

I just put the boat in the water yesterday after replacing the mainifolds, risers, elbows, impeller, thermostat and circulating pump over the winter. The boat idels at 170 on the guage then runs a little warmer at cruise. I don't know how accurate the guage is. I ran the boat for a few...

I removed the graphics (stickers) from the hull of my 1999 270. The gelcoat below the graphics is in much better condition and therefore produces a ghost image of the graphics. Any suggestions? I am considering either wet sanding 1200 then 2000 or using only compound. 3M "red" has been...

I recently had the exhaust manifolds removed and would like to prime and then paint the exposed metal before having new manifolds reinstalled. Can anyone reccomend a good primer that will adhere to the rust I may not be able to remove AND also withstand the higher temperatures of the head...

I have a 99' 270 sundancer with a bravo III and a 7.4 mpi big block. Does anyone know the which gear lube I should be using? Thanks, gmcleer